6. Changing blades
(1)Open the lever up to the stop. (Fig.
(2)Remove fitted blade
(3)Insert new blade up to the stop in the balde holder. (Fig.
(4)Close the lever. (Fig.
CAUTION:
◯Be sure to switch power OFF and disconnect the plug from the receptacle when changing blades.
◯Do not open the lever when plunger is moving.
NOTE:
◯Confirm the protrusions of blade inserted to the blade holder surely. (Fig. 4)
◯Confirm the blade located between the groove of roller. (Fig. 5)
7.Adjusting the blade operating speed
The jig saw is equipped with the electric control circuit which enables stepless speed control. To adjust the speed, turn the dial shown in Fig. 6. When the dial is set to “1”, the jig saw operates at the minimum speed (850 /min.). When the dial set to “5”, the jig saw operates at the maximum speed (3000/min.). Adjust the speed according to the material to be cut and working efficiency.
CAUTION:
⬤At low speed (dial setting: 1 or 2) do not cut a wood with a thickness of more than 3/8" (10 mm) or metal with a thickness of more than 1/32" (1 mm).
8. Adjusting the orbital operation
(1)This Jig Saw employs orbital operation which moves the blade back and forth, as well as up and down. Set the change knob shown in Fig. 7 to “0” to eliminate the orbital operation (the blade moves only up and down). The orbital operation can be selected in 4 steps from “0” to “III”.
English
|
| Blade | |
| II |
| |
Blade | I | Lever | |
holder | |||
| |||
| III |
| |
| Fig. 3 | Blade | |
|
|
Blade holder
Fig. 4 |
|
Blade | Blade |
Roller | Roller |
Fig. 5
Dial
Dial
CJ120V CJ120VA
Fig.6
11
