Hotpoint HDA2600K warranty Display What IT ME~S What to do

DISPLAY	WHAT IT ME~S	WHAT TO DO
BLOCKED	Similar to blocked drain as	Locate and remove the blockage in the drain system as
DRAIN	explained on page 8, but the C2	explained on page 8. To pump any remaining water out of
and	indicates that the drain is so	the machine:
--	clogged that the dishwasher	1. Latch door.
: #-I
--	cannot continue to operate in a	2. Select any cycle.
	satisfactory manner. Dishwasher
	will stop.	3. Touch “START” and then immediately touch “CLEAR/
		RESET.” (N~E: Warranty service does not cover
		household drain problems.)
-~:’9	Dishwasher will not go into	Restart the cycle. If C3 repeats, call for service.
	a drain out period. Dishwasher
	will stop.
8-8-1	There is too much water in the	The dishwasher is designed to automatically pump out extra
:/	dishwasher. If C4 appears after a	water as long as the door is latched. When you hear the
	power failure, this is normal and	motor stop running:
	the dishwasher will correct itself.	1. Unlatch the door and see ifall the water is gone. (It is
		normal for a small amount of water to remain in the
		bottom of tub to keep the water seal lubricated. )
		2. If you see water entering the dishwasher, close and latch
		the door. Shut off the water supply to the dishwasher.
		3. If water is gone and no water is entering the dishwasher,
		restart cycle.
		4. IfC4 repeats, shut off the water supply to the dishwasher.
		Call for service.
--~?	This can be caused by either of
	these reasons:
	Not enough water is entering the	Unlatch the door. If there is no water in the bottom of the
	dishwasher.	dishwasher, check the water supply to the dishwasher.
		● Is the dishwasher water supply turned on?
		(Valve usually located under the sink.)
	or	● Is the household water supply turned on?
		● If you use well or cistern water, is the supply adequate?
		If the water supply is adequate, try the cycle again. If C5
		repeats, call for service.
	The drain pump could be	Unlatch the door. If there is standing water in the bottom
	temporarily blocked (usually	of the dishwasher, relatch the door. Touch “STARTJ’ then
	caused by food particles such	immediately touch “CLEAR/RESET” to start the pump.
	as cereal).	If C5 continues to appear, you may need to do this several
		times to break up the blockage.
		(continued on next page)

9