Hotpoint EW84 manual Installation, Mains Connection, Siting the Cooker, Moving the Cooker

Page 4

Installation

WARNING – THIS APPLIANCE MUST BE EARTHED.

Mains Connection

Your cooker should have been checked to ensure that the voltage corresponds with your supply voltage, this is stated on the rating plate, which is situated on the outer rear panel. The model number and serial number are located on the front of the cooker, as shown on the Feature’s page.

The cooker must be connected by a competent person such as one who is a, NICEIC registered contractor to a suitable double-pole control unit with a minimum rating of 32A and a minimum contact clearance of 3mm (applicable to newer properties, older properties where a 30A double pole control unit and a minimum contact clearance of 3mm is acceptable).

The double pole control unit should be fitted adjacent to the cooker, in accordance with IEE regulations. The control unit must be within 2 metres of but not directly above the appliance and should be easily accessible in the event of an emergency.

The power supply cable should conform to B.S.6004 with a conductor size of 6mm2, minimum.

Access to the mains terminals is gained by removing the rear access cover. The mains cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable should be used to allow the cooker to be pulled out for servicing.

Ensure that the mains cable is routed away from any brackets affixed to the rear panel and is not trapped to the rear wall when pushing the cooker into position between cabinets.

Levelling

Four feet are fitted which can be adjusted up or down to set the height (900mm - 930mm) and level the cooker.

The feet can be simply screwed in or out to lower or raise the cooker.

After the correct height is achieved, lock the feet into position by tightening the locking nut using an open ended spanner.

CAUTION: Some soft floor coverings may get damaged if the cooker is not moved carefully.

NOTE: Ensure oven shelves are level by using a spirit level on the rod shelves.

Siting the Cooker

The cooker is designed to fit between kitchen cabinets spaced 600mm apart. The space either side need only be sufficient to allow withdrawal of the cooker for servicing and cleaning. It can be used with cabinets one side or both as well as in an angled corner setting. It can also be used freestanding.

Adjacent side walls which project above hob level, must not be nearer to the cooker than 150mm and should be protected by heat resistant material. Any overhanging surface or cooker hood should not be nearer than 650mm.

Note: This appliance must NOT be fitted on a platform.

Moving the Cooker

Before moving your cooker, switch off at the cooker control unit, ensure that it is cool. Open the grill door sufficiently to allow a comfortable grip on the underside front edge of the oven roof, avoiding any grill elements.

Radio Interference

This appliance conforms to EN 55014 regarding suppression of radio and television interference.

Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor covering is not damaged.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Instructions for Installation and Use Contents Introduction Installation Mains ConnectionSiting the Cooker Moving the CookerSafety Information AlwaysDo not Leave Deep FAT Frying Pans Unattended While Cooking Safety Advice in Case of a CHIP-PAN FireForce of the extinguisher is likely to tip the pan over Features Controls Hob ControlsMain Oven Light Cooling FanGrill Control Top Oven Main Oven FunctionsTop Oven Control Main Oven Control Conventional Heating Top Oven Variable Grilling Top OvenFan Oven Main Oven Traditional Main OvenFish Main Oven Rising Main OvenBread cycle Auto Cake cycle AutoElectronic Clock Automatic Cooking Feature Electronic Clock & Automatic Cooking Feature Setting the Minute MinderSeconds and then revert to the temperature set Auto Cooking TimerTemperature will be shown in the display To set the main oven to switch on and OFF immediatelyConventional Fan Temperature Conversion ChartOven Using the Ceramic Hob ChoiceSaucepans Suitable Always USECare of the Ceramic Hob Do NotRequirements for SafetyDeep fat frying Grilling Children should be kept awayGrill Chart RecessTop Oven Conventional Cooking Platewarming in the top ovenDo not place food or dishes on the floor of the oven Into the ovenMeat Pre Temperature Time approx If using aluminium foil, neverHeat LambFood Pre Temperature Time in mins PositionCooking temperature ranges Main Oven The Intelligent Cooking SystemCook Chart Fan oven mode Preheat Temperature Cooking TimeMeat BakingCook Chart Traditional mode Preheat Temperature Shelf Position Cooking TimeFish Care and Cleaning Cleaning of the Ceramic Hob‘Stay Clean’ Liners Chemical oven cleaners of any kindOven Fittings Oven InteriorsReplacement of the Oven Light Allow to cool if the oven has been usedCleaning the Doors Side Opening DoorsDrop Down Doors Remove the door inner glass as followsIf something goes wrong Hotpoint Service Cover Key Contacts

EW84 specifications

The Hotpoint EW84 is a versatile and efficient washing machine that has been designed to cater to the modern household's needs for cleaning clothes effectively while optimizing energy and water use. With its sleek design and user-friendly interface, the EW84 can easily fit into any laundry space, making it a popular choice among consumers.

One of the standout features of the Hotpoint EW84 is its impressive capacity. With a drum size of 8 kg, this machine is perfect for families and those who require frequent washing of larger loads. This allows users to clean more clothes in a single cycle, ultimately saving time and energy. The EW84 also boasts a spin speed of up to 1400 RPM, ensuring that clothes come out drier, which can significantly reduce drying times.

The Hotpoint EW84 integrates several cutting-edge technologies to enhance the washing experience. One of the most noteworthy is the Anti-Stain technology. This innovative feature is designed to tackle stubborn stains by automatically adjusting the washing parameters, such as temperature and soaking time. As a result, users can enjoy cleaner clothes without the need for pre-treatment.

Additionally, the EW84 is equipped with the Eco Tech feature, which helps users save on energy bills while still providing a thorough clean. This energy-efficient washing machine has an impressive A+++ energy rating, indicating its commitment to reducing energy consumption without compromising on performance. The Eco Mode allows users to wash clothes at lower temperatures, further conserving energy.

User convenience is another priority for the Hotpoint EW84. It features a digital display that provides clear information on selected programs, remaining time, and load recommendations. The machine offers a variety of wash programs catering to diverse fabric types and needs, including Delicates, Wool, and rapid wash options for those in a hurry.

Moreover, the EW84 incorporates a delay start function that allows users to schedule washes at their convenience, making it easier to fit laundry into busy lifestyles. The water balance system ensures that the machine evenly distributes the load, preventing vibrations and enhancing overall efficiency.

In summary, the Hotpoint EW84 delivers a combination of capacity, efficiency, and innovative technology that makes washing clothes an easier and more effective task. Its thoughtful design and feature set ensure that it meets the demands of today’s households while maintaining high standards for performance and sustainability.
Top Page Image Contents