Solid Sbte Monitor System

It keeps an eye on things for you.

9? 9 ? 9

@Red signal lightflashes to tell you when either door is open.

@Signal lighttellsyou that the Door Alarm beeper has been set to sound after either door has been open 30 seconds.

@Red signal light tells you when freezer foodkeeping temperature is above normal.

@Lighted word NORMAL indicates that no failure has been detected by the diagnostic system.

@Flashing diagnostic codes in the display warn you when:

❑frozen foods should be checked.

❑power has been interrupted.

❑icemaker may not be operating properly.

❑defrost system has failed.

❑freezer control may need to be set for a colder temperature.

What these codes mean—and what to do when they appear—is summarized on the inside of the freezer compartment door and explained more thoroughly on the following pages.

@STATUS CHECKpadputsa review of the electronic diagnosis of five coded functions at your fingertip and also allows you to erase codes and reset the display.

@Electronic control allows you to turn night light in water-and-ice service on and off.

@Electronic control allows you to select ice cubes or crushed ice, and signal light confirms your choice.

When your refrigerator

is first plugged in...

All panel lights come on for five seconds, a beep sounds, and lights go off except as follows:

●PF flashes in the display. Touch STATUS CHECK-RESET pad to erase it.

●Word NORMAL glows.

c Red WARM TEMPERATURE light glows if freezer compartment temperature is higher than normal. It goes off when proper foodkeeping temperature is reached.

●Door alarm beeper is activated and light on DOOR ALARM pad glows.

●CRUSHED ice selection light glows.

●Red DOOR OPEN light flashes if either door is open, goes out when doors are shut.

●Night light in water-and-ice service is off.