Hotpoint OS89IX, OS89CIX, OS89HP, OS89CHP operating instructions Care and maintenance

Page 11

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out any work on it.

Cleaning the appliance

The stainless steel or enamel-coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. Use specialised products for the removal of stubborn stains. After cleaning, rinse and dry thoroughly. Do not use abrasive powders or corrosive substances.

The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products.

All accessories - with the exception of the sliding racks - can be washed like everyday crockery, and are even dishwasher safe.

￿Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack.

For more thorough cleaning purposes, the oven door may be removed:

1.Open the oven door fully (see diagram).

2.Use a screwdriver to lift up and turn the small levers F located on the two hinges (see diagram).

Inspecting the seals

Check the door seals around the oven at regular GB intervals. If the seals are damaged, please contact

your nearest After-sales Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

 

1. Remove the

Oven

glass cover of the

compartment

lamp-holder.

 

 

2. Remove the

Lamp

light bulb and

 

 

replace it with a

 

similar one:

Glass cover

halogen lamp

 

 

voltage 230 V,

 

wattage 25 W,

 

cap G 9.

3. Replace the glass cover (see diagram).

￿Do not touch the light bulb directly with your hands.

Sliding rack kit assembly

To assemble the sliding racks:

1.Remove the two frames, lifting them away from the

spacers A (see figure).

A

F

Left

Right guide

guide rail

rail

B

 

 

 

C

 

 

of

 

 

Direction

 

 

xtraction

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

3. Grip the door on the two outer sides and close it approximately half way. Pull the door towards you lifting it out of its seat (see diagram). To replace the door, reverse this sequence.

D

3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are at the bottom.

4. Finally, fit the frames on the spacers A.

11

Image 11
Contents Oven Operating InstructionsPositioning InstallationElectrical connection Appliance SpecificationsDisplay Description of the applianceOverall view Control panelOven structure Setting the clockSetting the timer Start-up and useSet a duration for universal cooking functions only Page Programming cooking Practical cooking adviceDripping Rack Respecting and conserving the environment Precautions and tipsGeneral safety DisposalCare and maintenance Page Page Page After Sales Service GBGuarantee