Using your Aroma Coffee™ 12
Before first use
Before brewing coffee in your new coffee maker, clean thoroughly as follows;
1.With warm soapy water clean the carafe and removable filter basket. Rinse with clean water and dry.
2.Open the hinged top lid and fill the water reservoir with cold tap water to the maximum level marked on the water level gauge.
3.Place the glass carafe into position on the warming plate of the coffee maker.
4.Plug the coffee maker into a
5.Press the power switch ‘ON’ to commence the brewing cycle, without ground coffee or the mesh filter.
6.At the end of the first cycle turn the coffee maker off and wait ten minutes. Remove the carafe and empty out water.
7.Replace the carafe, refill the water reservoir and commence the brewing cycle without ground coffee or mesh filter.
Your Aroma Coffee™ 12 is now ready for use.
Brewing coffee
1.Place your coffee maker on a flat, level surface.
2.Open the hinged top lid and fill the water reservoir with cold tap water up to the maximum level marked on the water level gauge for the desired amount of coffee.
Note: A minimum of two cups is required.
Note: Do not use the carafe to fill the unit with water as it may contaminate the insides of your coffee maker with coffee residue.
3.Insert the permanent mesh filter into the filter holder.
4.Spoon the desired amount of ground coffee into the filter.
Note: We recommend that you allow one tablespoon of ground coffee for each cup of brewed coffee. However you may vary the quantity according to your taste.
Note: If you place too much ground coffee into the filter, coffee grinds may overflow during the brewing process and be deposited in the carafe.
5.Close the hinged top lid so it clicks shut.
6.Place the empty glass carafe into position on the warming plate.
7.Plug the coffee maker into a
8.Press the power switch ‘On’.
Aroma Coffee 12 (PC3600 and PC3610); once the coffee maker is switched on, the power switch will illuminate.
Aroma Coffee 12 Digital (PC4700); once the coffee maker is switched on, the small power light next to the power button will illuminate. See ‘How to use the Electronic Programming’ section for further details on programming the automatic brew feature.
9.When the brewing cycle is completed the warming plate will keep the coffee hot as long as the coffee maker is switched on.
Note: There is no need to wait between brewing cycles. As soon as you have brewed one pot of coffee, you may immediately brew another carafe.
10.Switch the coffee maker ‘Off’ after use and unplug from the power outlet.
4