Fax +1 305 430 9692
Copies of the I/B. Please reproduce them without any changes except under special instruction from Team International USA. The pages must be reproduced and folded in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm height). When folding, make sure you keep the good numbering when you turn the pages of the I/B. Don’t change the page numbering. Keep the language integrity. Print only what is inside the frame,
BEFORE THE FIRST USE
•Wash the Stainless Steel Mixing Cup (6) in warm, soapy water or in a dishwasher; rinse and let dry.
•Clean the Mixing Spindle (4):
1.Fill the Mixing Cup (6) halfway with warm, soapy water and place into position. Plug in the appliance on a wall socket. Hold the On/Off Switch (7) down for
2.Discard soapy water and add clean, fresh water to the Mixing Cup (8). Place Mixing Cup (6) back into position and hold the On/Off Switch (7) down for
3.Remove Mixing Cup (6) and discard water.
4.Dry all parts thoroughly with a soft, dry cloth.
NOTICE: Do not attempt to remove the Mixing Spindle (4) from the Motor Housing (1), as it is permanently attached.
ASSEMBLY AND USE
CAUTION!
•Do not touch the Mixing Spindle (4) with a hand, spatula, spoon, etc. during mixing.
•Do not mix hard or frozen ingredients.
•Limit mixing time to three minutes to avoid overheating the motor. Allow the product to cool down at least one minute after each
•To prevent the motor from overheating, let the product completely cool for at least 15 minutes after five cycles of usage.
1.Place the Milkshake Maker on a flat, level, stable,
2.Fill the Mixing Cup (6) up to the "MAX" mark and carefully insert the Mixing Cup around the Mixing Spindle (4). Hook the Mixing Cup under the Safety Switch (2) and rest the Mixing Cup on the Cup Rest (5).
5USK DRM 39135 - 120501