ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrenches and your own phillips screwdriver 
and
rubber mallet 
.
As you assemble the elliptical exerciser, use the drawings below to identify the small parts used in assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 21. The number following the parentheses is the quantity used in assembly. Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it is preassembled.
M4 x 16mm | M4 x 16mm | M8 Jam Nut | M10 Nylon | M10 Split | M10 Washer |
Round Head | |||||
Screw | Screw | Locknut | Washer | ||
M8 x 44mm Button | M8 x 41mm Button | M10 x 55mm | |||
Screw | Bolt | Carriage Bolt | |||
M10 x 20mm Button |
| M10 x 90mm Carriage |
| ||
Screw |
| Bolt |
|
| |
|
| Bolt Set |
|
| |
1.Identify the Front Stabilizer (8). While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 90mm Carriage Bolts (96) and two M10 Nylon Locknuts (89).
1 |
89 |
1 |
96 |
8 |
4
