2.Identify the Rear Stabilizer (6). While another person lifts the back of the Frame (1), attach the Rear Stabilizer to the Frame with the Support Plate (64) and four M8 x 44mm Button Screws (84).
3. Have another person hold the Upright (2) in the posi- |
tion shown. |
Connect the Upper Wire Harness (30) to the Lower |
2
1
6
64
84 
84
Wire Harness (42). Insert the connectors on the Wire |
Harnesses up into the Upright (2). Carefully pull the |
upper end of the Upper Wire Harness to remove |
the slack from the Wire Harnesses. |
Slide the Upright (2) onto the Frame (1). Be careful to |
avoid pinching the Wire Harnesses (30, 42). Attach |
the Upright with six M10 x 20mm Button Screws (49) |
and six M10 Split Washers (73). Be careful to avoid |
damaging the Wire Harnesses with the Button |
Screws. Do not tighten the Button Screws yet. |
4. Apply a generous amount of the included grease to |
the Pivot Axle (25). Next, insert the Pivot Axle into the |
Upright (2) and center it. Reapply grease to both ends |
of the Pivot Axle. |
Slide an Upper Body Arm Cover (26) onto the indicat- |
ed tube on an Upper Body Arm (29). Next, slide the |
3
2 
49 73
30 
42 
1
49
73
49
73
Do not pinch the wire harnesses during this step.
Upper Body Arm and the Upper Body Arm Cover onto |
the left end of the Pivot Axle (25). |
Have another person hold the Left Handlebar (21) |
near the Upright (2). Slide a Handlebar Cover (31) |
onto the lower end of the Left Handlebar. |
Slide the upper end of the Left Handlebar (21) into the |
tube on the front of the Upright (2), while sliding the |
lower end of the Left Handlebar onto the Pivot Axle |
(25). Attach the upper end of the Left Handlebar with |
two M8 x 41mm Button Bolts (98) and two M8 Jam |
Nuts (97); Make sure that the Jam Nuts are resting |
in the hexagonal holes in the Left Handlebar. |
Attach the lower end of the Left Handlebar with an M8 |
x 41mm Button Bolt (98) and an M8 Jam Nut (97). |
Then, press the tabs on the Handlebar Cover (31) into |
the Upper Body Arm Cover (26). |
Repeat this step with the other Upper Body Arm (29) and the Right Handlebar (22).
Hold the halves of the Upright Cover (3) around the tube on the front of the Upright (2). Attach the Upright Cover with an M4 x 16mm Round Head Screw (69).
4
3
22
| 98 | |
69 |
|
|
|
| 97 |
|
| 2 |
|
| Grease |
21 |
| Tube |
|
| 25 |
|
| 26 |
|
| 29 |
98 | 31 | 29 |
|
| |
| 97 |
|
5
