Wells FT-18 operation manual Cleaning Instructions

Page 8

CLEANING

CAUTION:

ELECTRIC SHOCK HAZARD

DO NOT submerge or immerse toaster in water.

CAUTION:

BURN HAZARD

Exposed portions of toaster are hot. Use care when working around the platens. Use insulated handles to raise and lower platens.

CLEANING INSTRUCTIONS

PRECAUTIONS:

Press MENU 4 (cleaning mode). Allow toaster to

 

cool to 275ºF.

 

NOTE: If MENU 4 has been programmed to

 

anything other than 275ºF, press POWER SWITCH

 

OFF and allow unit to cool for at least 10 minutes.

 

Be sure to wear protective gloves.

FREQUENCY:

Daily

TOOLS

Protective gloves

 

Cleanser manufactured specifically for use on

 

toaster surfaces.

 

Applicator pad with handle

 

Metal spatula with rounded corners

 

Clean dry towels.

 

 

 

 

IMPORTANT: DO NOT SUBMERGE OR IMMERSE TOASTER IN WATER.

Loosen debris on surface of platens with metal spatula.

Apply cleanser to cleaning pad. Scrub exposed surface of upper platens, first, then scrub exposed surface of lower platen.

Wipe exposed surface with a towel moistened with clear water. Wipe upper platens first, then lower platen. Rinse the towels often.

Remove CRUMB TRAY. Wash and rinse, then reinstall.

Wipe outside surfaces with a towel moistened with clear water.

6

Image 8
Contents 205a Important do not Discard this ManualLimited Warranty Statement Introduction Table of ContentsSpecifications Features & Operating Controls Precautions and General Information Burn HazardInstallation Agency Listing InformationTimer Operation OperationWARM-UP Seasoning the PlatensCleaning Cleaning InstructionsMaintenance Procedures Adjust Platen TensionAdjustment Location To AdjustCleaning Programming Time and Temperature Left Section NoteStandard Operation Notes Program Temp Time FunctionProgramming Time Right Section Troubleshooting Suggestions Symptom Possible Cause Suggested RemedyParts & Service Description