DeLonghi DEDW654FI Starting Awashing Program, Drain Hose Connection, Positioning the Appliance

Using Your Dishwasher

STARTING AWASHING PROGRAM

Wash Cycle Table

NOTE: Star () means the need to fill rinse aid into the Rinse Aid Dispenser.

Program	Cycle Selection	Description	Detergent	Running	Energy	Water	Rinse
	Information	of Cycle	pre/main	time(min)	(Kwh)	(L)	Aid
	Auto sensing wash, lightly,	Pre-wash (45 °C)
		Autowash(50-60 °C)
	normally or heavily soiled		5/28.75g
Auto		Rinse		120~170	1.1~1.4	10~13.5
	crockery, with or with out		(Or All in1)
		Rinse (60 °C)
	dried-on food
		Drying
		Pre-wash(50 °C)
	For heaviest soiled crockery,	Wash (65 °C)
		Rinse	5/28.75g
Intensive	and normally soiled pots,			155	1.45	17.0
		Rinse
	pans, dishes etc with dried		(Or All in1)
		Rinse (65°C)
	on soiling.
		Drying
	For heavily soiled loads,	Pre-wash(45°C)
		Wash (55 °C)
Heavy	such as pots, plates,		5/28.75g	170	1.15	13.5
		Rinse
	glasses and lightly
		Rinse (60 °C)	(Or All in1)
	soiled pans.
		Drying
Normal	Standard daily cycle for	Pre-wash
		Wash (55 °C)	5/28.75g
	normally soiled loads,	Rinse		175	0.62	12.0
	such as pots, plates,		(Or All in1)
(*AS/NZS 2007.1)		Rinse(45°C)
	glasses.
		Drying
		Pre-wash
	For lightly soiled crockery	Wash (40 °C)
Glass		Rinse	5/28.75g	115	0.85	13.5
	and glass.
		Rinse(60°C)
		Drying
	For lightly soiled loads that	Pre-wash(50°C)
		Wash(60°C)
60 Min	do not need excellent		5/28.75g	60	0.8	9
		Rinse (50°C)
	drying efficiency.
		Drying
Rapid	A shorter wash for lightly	Wash (40 °C)
		Rinse	20g	40	0.5	10
	soiled loads that do not
		Rinse (45 °C)
	need drying.
Soak	To rinse dishes that you plan	Pre-wash		8	0.01	3.8
	to wash later that day.

Installation

Drain Hose Connection

ŸInsert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to avoid bending or crimping it. The top of the hose must be at a height less than 1000mm. The free end of the hose must not be immersed in water to avoid back flow.

Syphon Connection

ŸInsert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making sure to avoid bending or crimping it. The top of the hose must be less than 1000mm.

How to Drain Excess Water from Hoses

ŸIf the sink is more than 1000mm higher than the floor, the excess water in the hose cannot be drained directly into the sink. It will be necessary to drain excess water from the hose into a bowl or suitable container that is held outside and lower than the sink.

Water Outlet

ŸConnect the water drain hose. The drain hose must be correctly fitted to avoid water leaks. Ensure that the water drain hose is not kinked or squashed.

Extension Hose

ŸIf you need a drain hose extension, make sure to use a similar drain hose.

ŸIt must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.

Electrical Connection

ŸConnect the appliance power cord in accordance with the precautions outlined on page 7.

Positioning the Appliance

ŸPosition the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can be positioned either to the right or the left sides to facilitate proper installation.

ŸAffix the condensation strip under the work surface of the cabinet. Ensure the condensation strip is flush with edge of the work surface.

Condensation

Strip

NOTE:

* AS/NZS 2007.1: This program is the test cycle.

The information for comparability test in accordance with AS/NZS 2007.1, as follows:

ŸCapacity: 15 setting

ŸPosition Upper basket: Upper wheels on rails

ŸRinse aid setting: 6

ŸOpen the door slightly 50mm to assist in drying of the dishes after every wash

Front

NOTE

The top of the hose must be less than 1000mm.

Drain pipe

A

B

Counter

MAX 1000mm

¦40mm

Page 22 Page 11