Majestic Appliances 3379 Install ON/OFF Switch, Thermostat Connection Optional, plug, 20004555

Vermont Castings Radiance Vent-Free Gas Heater
		Install ON/OFF Switch
		The switch assembly parts are found in the parts bag.
		1. Attach switch assembly to left rear side of stove
		shroud using two screws and existing holes in
		shroud. (Fig. 16)
	Rheostat	2. Run wires down back of stove, under bottom of rear
		shroud to valve.
		3. Attach wires to valve terminals. (Fig. 17)
Retaining Nut
Control Knob	ST347a	Switch	Existing
		Assembly
			Holes
Fig. 14 Attach rheostat to control panel. Valve may look
different.

MOTORDisconnect power before servicing.

BLK BLK BLK SNAPSTAT

		Screws	ST315
BLK	WHT	Fig. 16 Attach switch assembly to rear shroud.
WHT GRN	RHEOSTAT
	ON/OFF
POWER
	ST196	TH
Fig. 15 #2767 / FK26 Fan Wiring Diagram		TP
	WARNING	TPTH
The optional fan kit is equipped with a three-
prong (grounding) plug for your protection against
shock hazard and should be plugged directly into
a properly grounded three-prong outlet. Do not			ST228
cut or remove the grounding prong from this		Fig. 17 Attach switch wires to valve.
plug.
NOTE: If you are installing the fan kit after the stove is		Thermostat Connection (Optional)
		Use only a thermostat rated for 500 - 750 millivolts.
in its final location, follow same steps mentioned
		Do not use low voltage (24V) thermostats.
previously with the exception of disengaging only the
right side of the outer shroud.		Check the table below for the appropriate gauge
		thermostat wire to use for the length of lead required in
		your installation.
		Thermostat Wire / Gauge	Maximum Run
		18	40 feet
		20	25 feet
		22	16 feet
		1. Install the wall thermostat in the desired location and
		run the wires to the stove location. Terminate these
		leads with 1/4Ó female connectors.
		2. Connect the thermostat wires to the valve. (Fig. 17)

12 20004555