Majestic Appliances 3372 Assembly Procedures, Tools Required, Hardware Bag Contents, 20004555

Vermont Castings Radiance Vent-Free Gas Heater

Assembly Procedures

Read these instructions thoroughly before starting the assembly. Follow procedures in the order given. Inspect the stove for damage before starting the assembly. Do not install this stove if any damage is evident. Contact your dealer immedi- ately.

The Radiance is shipped on its back, mounted to a wooden pallet. It is fully assembled, although packing materials must be removed from the firebox and the Log Set installed. Connection to the gas supply must be performed only by a qualified gas technician who should also verify that adequate ventilation is available to support proper burner function.

Installation of optional accessories, such as the Fan, Glass/Catalyst, or thermostat, is most easily accom- plished before the gas supply connection is made.

Tools Required

¥	Stub-handled Phillips screwdriver	¥ work gloves
¥	Standard Phillips screwdriver	¥ knife

¥Standard flat-blade screwdriver

¥ Tape measure ¥ needlenose pliers

Hardware Bag Contents

•Porcelain Handle (Front Door)

•Control Door Handle & Screw

•(2) Bags of Lava Rock

•(6) 10 x 1/2Ó Screws

•Bracket, Wire Switch

•Registration Card & Manual

•(4) CS, Hex Hd 3/8-16 x 1 Gr 2-Z

•(4) Washer, Fl 3/8-Z

Unpacking the Radiance

Caution: Enamelled castings can chip easily! Handle enamelled castings carefully to avoid damage.

1.Cut the shipping straps.

2.Unpack the top grate and screen from the carton, and set them aside.

Remove the Front, Screen and Logs

Remove the Front panel, the Screen panel, the Log Set and hardware bag from the firebox before position- ing the stove.

1.Remove the accessory package from the top of the stove. The manual, hardware package, and lava rocks are packed on top of the firebox. Set these aside.

2.Remove the Front Plate. Grasp one side and the bottom, and lift the front plate as a unit (the control door attaches to the stove front). Swing the bottom edge out and away from the stove body, (Fig. 5)

3.Remove the screen frame. (Fig. 6)

4.Remove the Log Set. Lift out the package and any packing material from the burner tray and firebox. Unpack the log set and inspect each piece for damage. DO NOT INSTALL DAMAGED LOGS. Set the logs aside out of the way.

	ST139
Fig. 5	Remove the front plate.
	Screen Hooks
	ST187a

Fig. 6 Lift screen from firebox.

20004555 9