Remote Control Unit, Inserting the batteries

ENGLISH

REMOTE CONTROL UNIT

Following the procedure outlined below, insert the batteries before using the remote control unit.

Range of operation of the remote control unit

Point the remote control unit at the remote control sensor as shown on the diagram at the left.

NOTES:

• The remote control unit can be used from a straight distance of approximately 7 meters/23 feet, but this distance will shorten or operation will become difficult if there are obstacles between the remote control unit and the remote control sensor, if the remote control sensor is exposed to direct sunlight or other strong light, or if operated from an angle.

• Neon signs or other devices emitting pulse-type noise nearby may result in malfunction, so keep the set as far away from such devices as possible.

30° 30°

Approx. 7 m/23 feet

Inserting the batteries

For remote control unit (RC-872)

qPress as shown by the arrow and slide off.

w Insert the R6P/AA batteries properly, as	e Close the lid.
shown on the diagram.

For multi-source remote control unit (RC-873)

qPress as shown by the arrow and slide off.

w Insert the R03/AAA batteries properly, as e Close the lid. shown on the diagram.

NOTES:

•Be sure the polarities are correct. (See the illustration inside the battery compartment.)

•Remove the batteries if the remote control transmitter will not be used for an extended period of time.

•If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

•Even if less than a year has passed, replace the batteries with new ones if the set does not operate even when the remote control unit is operated nearby the set. (The included battery is only for verifying operation. Replace it with a new battery as soon as possible.)

•When replacing the batteries, after removing them wait for about one minute before inserting the new batteries.