DeLonghi DE Cleaning the drip tray and condensate tray, Cleaning the inside of the coffee maker

If you make a number of cappuccinos one after the other, the metal cup tray becomes hot.

Wait for it to cool down before touching it and handle it from the front only.

To clean (with the machine on):

•Remove the drip tray (fig. 26), empty and clean.

•Empty the grounds container and clean thoroughly to remove all residues left on the bottom. This can be done with the spatula on the brush provided.

•Check the condensate tray (red) and empty if necessary.

Important!

When removing the drip tray, the grounds container must be emptied, even if it contains few grounds.

If this is not done, when you make the next coffees, the grounds container may fill up more than expected and clog the machine.

Cleaning the drip tray and condensate tray

Important!

The drip tray is fitted with a level indicator (red) showing the level of water it contains (fig. 27).

Before the indicator protrudes from the cup tray, the drip tray must be emptied and cleaned, otherwise the water may over- flow the edge and damage the appliance, the surface it rests on or the surrounding area.

To remove the drip tray:

1.Remove the drip tray and the grounds container (fig. 26);

2.Empty the drip tray and grounds container and wash them;

3.Check the red condensate tray and empty if necessary.

4.Replace the drip tray and grounds container.

Cleaning the inside of the coffee maker

Danger of electric shock!

Before cleaning internal parts, the machine must be turned off (see “Turning off”) and unplugged from the mains power supply.

Never immerse the coffee maker in water.

1.Check regularly (about once a month) that the inside of the appliance (accessible after removing the drip tray) is not dirty. If necessary, remove coffee deposits with the brush provided or a sponge.

2.Remove the residues with a vacuum cleaner (fig. 28).

Cleaning the water tank

1.Clean the water tank (A17) regularly (about once a month and whenever you replace the water softener filter (if provided) with a damp cloth and a little mild washing up liquid.

2.Remove the filter (if present) and rinse with running water.

3. Replace the filter (if provided), fill the tank with fresh wa- ter and replace the tank.

Cleaning the coffee spouts

1.Regularly clean the coffee spouts with a sponge or cloth (fig. 29A).

2.Check the holes in the coffee spout are not blocked. If necessary, remove coffee deposits with a toothpick (fig. 29B).

Cleaning the pre-ground coffee funnel

Check regularly (about once a month ) that the pre-ground coffee funnel (A6) is not blocked. If necessary, remove coffee deposits with the brush (D2) supplied.

Cleaning the infuser

The infuser (A11) must be cleaned at least once a month.

Important!

The infuser may not be extracted when the machine is on.

1.Make sure the machine is correctly turned off (see “Turn- ing the appliance off” on page 9).

2.Remove the water tank.

3.Open the infuser door (fig. 30) on the right side.

4.Press the two red release buttons inwards and at the same time pull the infuser outwards (fig. 31).

5.Soak the infuser in water for about 5 minutes, then rinse under the tap.

Important!

RINSE WITH WATER ONLY

NO WASHING UP LIQUID - NO DISH WASHER

Clean the infuser without using washing up liquid as it could be damaged.

6.Use the brush (D2) to remove any coffee residues left in the infuser housing, visible through the infuser door.

7.After cleaning, replace the infuser by sliding it onto the internal support; then push the PUSH symbol fully in until it clicks into place.

infuser support

16