DeLonghi 10.13, GB, DE, ECAM28.46X Delivering HOT Water and Steam, Adjusting the amount of froth

Adjusting the amount of froth

Turn the froth adjustment dial on the milk container lid to adjust the amount of froth on the milk delivered while making drinks with milk.

Dial	Description	Recommended for…
position
	No froth	LATTE/
		HOT MILK
	Min. froth	FLAT WHITE
	Max. froth	CAPPUCCINO/ HOT MILK
		(FROTHED MILK)

Making drinks with milk automatically

The CAPPUCCINO, LATTE, FLAT WHITE and HOT MILK buttons on the control panel enable these drinks to be prepared automatically.

Proceed as follows:

1.Fill the milk container and attach it as described above.

2.Turn the froth adjustment dial on the milk container lid to the position corresponding to the required froth.

3.Press the button corresponding to the required drink. The name of the drink selected is displayed together with a progress bar which gradually fills as preparation progresses.

4.After a few seconds, frothed milk is delivered from the milk spout into the cup below. For drinks with coffee, the machine automatically makes the coffee after delivering the milk.

Please note!

•If during delivery you want to stop preparation, press the corresponding button.

•At the end of delivery, to increase the quantity of milk or coffee in the cup, just press (within 3 seconds) the button corresponding to the drink being made.

•Do not leave the milk container out of the refrigerator for long periods. The warmer the milk (5°C is ideal), the poor- er the quality of froth produced.

Cleaning the milk frother with the CLEAN button

Important! Danger of burns

When cleaning the internal tubes of the milk container, a little hot water and steam leak out of the frothed milk spout.

Avoid contact with splashes of water.

“SET DIAL TO CLEAN” flashes on the display each time you use a milk function. To eliminate all milk residues, proceed as fol- lows:

1.Leave the milk container in the machine (you do not need to empty it);

2.Place a cup or other recipient under the frothed milk spout.

3.Turn the froth adjustment dial to “CLEAN” (fig. 22). A progress bar appears and gradually fills as the operation proceeds together with “Cleaning underway, Please wait”. Cleaning stops automatically.

4.Turn the dial back to one of the froth selections.

5.Remove the milk container and always clean the steam connection nozzle with a sponge.

Please note!

•To prepare a number of cappuccinos or milk based coffees, clean the milk container after you have prepared the last drink only.

•The milk container can be kept in the refrigerator.

•In some cases, to clean you must wait for the appliance to heat up.

Programming the quantity of coffee and milk in the cup for the CAPPUCCINO, LATTE, FLAT WHITE and HOT MILK buttons

The appliance is set by default to automatically deliver standard quantities.

To change these quantities, proceed as follows:

1.Place a cup under the coffee and milk spouts.

2.Press and hold the button corresponding to the drink you want to programme until the message “PROGRAM MILK Program quantity” is displayed.

3.Release the button.

The appliance starts delivering milk.

4.Once the required quantity of milk has been delivered into the cup, press the button again.

5.The appliance stops delivering milk and after a few sec- onds the coffee is delivered into the cup. “PROGRAM COF- FEE Program quantity” is displayed.

6.Once the required quantity of coffee has been delivered into the cup, press the button.

Coffee delivery stops.

The machine is now reprogrammed with the new quantities of milk and coffee.

DELIVERING HOT WATER AND STEAM

Important! Danger of burns.

Never leave the machine unsupervised while delivering hot water or steam.

14