DeLonghi Resetting and Troubleshooting for Your Coffeemaker

16.7 Resetting factory default settings (reset)

If you change the original values, the factory default values can be reset as follows:

• Press the button (the light over the button comes on) then press repeatedly until the applian- ce displays:

RESET TO DEFAULT NO

•Press the button and the appliance displays "RESET TO DEFAULT YES”

•Press the button to reset the factory default values;

•The appliance is now reset to the factory default settings and the READY message is displayed.

17 CHANGING THE LANGUAGE

To change the language, press the button for at least 5 seconds until the appliance displays the installation message in various languages. To select the required language, follow the instructions in section 4.1.

18 TROUBLESHOOTING

MESSAGE		MEANING	WHAT TO DO
	• The water tank is empty or is positioned		• Fill the water tank as described in sec-
		incorrectly.	tion 6, note 6 and insert it fully.
FILL TANK	•	The tank is dirty or encrusted with lime	• Rinse or descale the tank.
		scale.
GROUND TOO FINE ADJUST MILL	•	The appliance cannot make coffee.	• Insert the hot water spout, press the
AND			button and deliver water from the spout
			for a few seconds.
INSERT WATER SPOUT AND	•	The coffee runs off too slowly.	• Turn the grinding regulator (fig. 12) one
PRESS OK			click clockwise (see section 8).
	• The grounds container is full or missing.		• Empty the grounds container and clean
EMPTY GROUNDS CONTAINER			as described in section 6, note 7, then
			replace.
	•	After cleaning, the grounds container	• Open the service door and insert the
INSERT GROUNDS CONTAINER		has not been replaced.	grounds container.
ADD PRE-GROUND	•	With the function selected, the pre-	• Add the ground coffee as described in
COFFEE		ground coffee has not been poured into	section 9.
		the funnel.
	• The coffee beans have run out.		• Fill bean container.
	• If the coffee grinder is very noisy, this		• Contact an authorized De' Longhi servi-
FILL BEANS CONTAINER		means a small stone in the coffee beans	ce center.
		has blocked the mill.
	• This indicates the presence of lime scale		• The descaling procedure, described in
DESCALE		in the appliance.	section 16.3, needs to be performed as
			soon as possible.

20