DeLonghi ESAM3500 manual Clock, Changing and Setting the Menu Parameters

NOTE 2: If it is hard to insert the infuser, before inserting it, squeeze to size by pressing it vigorously from above and below at the same time, as shown in Figure 31.

NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from the outlet, then plug in again. Wait for all the lights to go off after the self-diagnosis, then open the door and replace the infuser.

15.3Cleaning the milk container Proceed as follows:

• Remove the milk spouts (fig. 32) and the milk intake tubes.

•Wash the container and lids in a dishwasher or in hot soapy water.

•Make sure there are no milk residues inside the two holes in the lids of the milk container indicated by the arrows in the figure or the milk intake tubes.

• To replace the components of the lid with the wor- ding "STEAMED MILK - LATTE", insert the milk spout and milk intake tube (the softer one) in the hole in the lid as shown in fig. 20.

• To replace the components of the lid with the wor- ding "FROTHED MILK - CAPPUCCINO", insert the milk spout and milk intake tube (the harder one) in the hole in the lid as shown in fig. 20.

Note: To avoid using the wrong intake tube, the “STEAMED MILK –LATTE” tube cannot be inserted in the “FROTHED MILK – CAPPUCCINO” lid and the “FROTHED MILK – CAPPUCCINO” tube cannot be inserted in the “STEAMED MILK – LATTE” lid.

16 CHANGING AND SETTING THE MENU PARAMETERS

After pressing the button, when the appliance is ready, you can use the internal menu to modify the fol-

lowing parameters and functions:		•	Coffee temperature
•	Clock	• Length of time the appliance remains on
•	Auto-start time	•	Water hardness
•	Descaling process	•	Factory default values

16.1 Setting the clock

To set the clock, proceed as follows:

•Press the button (the light over the button comes on) then press the button repeatedly until the appliance displays:

CLOCK 00:00

• Press the	button to set the clock. (If you hold the	button down, the time is changed
rapidly).

•Press the button to confirm the value;

•Press the button to exit programming mode or to change other parameters.

16.2 Setting auto-start time

This programs the time the appliance will come on automatically and be ready for use.

•Make sure the clock on the appliance is set as described above.

•Press the button (the light over the button comes on) then press the button repeatedly until the appliance displays:

17