DeLonghi ECAM45.760 Cleaning the water tank, Cleaning the coffee spouts, Cleaning the infuser

Cleaning the inside of the coffee machine

Danger of electric shock!

Before cleaning internal parts, the machine must be turned off (see “Turning off”) and unplugged from the mains power sup- ply. Never immerse the coffee machine in water.

1.Check regularly (about once a week) that the inside of the appliance (accessible

	after removing the drip
	tray) is not dirty. If neces-
	sary, remove coffee deposits
	with the brush supplied and
	a sponge.
	2. Remove the residues with a
33	vacuum cleaner (fig. 33).

Cleaning the water tank

1.Clean the water tank (A16) regularly (about once a month and whenever you replace the water softener filter (if pre- sent) with a damp cloth and a little mild washing up liquid.

2.Remove the filter (if present) and rinse with running water.

3. Replace the filter (if present), fill the tank with fresh water and replace the tank.

Cleaning the coffee spouts

1.Clean the coffee spouts regularly with a sponge or cloth (fig. 34).

2.Check the holes in the cof- fee spout are not blocked.

If necessary, remove coffee deposits with a toothpick (fig. 34).

34

Cleaning the pre-ground coffee funnel

Check regularly (about once a month ) that the pre-ground cof- fee funnel (A4) is not blocked.

If necessary, remove coffee deposits with the brush (D2) supplied.

Cleaning the infuser

The infuser (A15) must be cleaned at least once a month.

Important!

The infuser may not be extracted when the machine is on.

1.Make sure the machine is correctly turned off (see “Turning off”, page 9).

2.Extract the water tank (fig. 4).

3.Open the infuser door (fig. 35) on the right side of the appliance.

	PUSH
H
PUS
35	36

4.Press the two red release buttons inwards and at the same time pull the infuser outwards (fig. 36).

5.Soak the infuser in water for about 5 minutes, then rinse under the tap.

Important!

RINSE WITH WATER ONLY

NO WASHING UP LIQUID - NO DISH WASHER

Clean the infuser without using washing up liquid as it could be damaged.

6.Use the brush (D2) to remove any coffee residues left in the infuser housing, visible through the infuser door.

7.After cleaning, replace the infuser by sliding it onto the internal support (fig. 37), then push the PUSH symbol fully in until it clicks into place.

Infuser support

37

Please note!

If the infuser is difficult to insert, before insertion, adapt it to the right size by pressing the two levers shown in fig. 38.

Large lever

Small lever

38

8.Once inserted, make sure the two red buttons have snap- ped out (fig. 39).

17