The Floor Stands
Mounting The Speakers
The rear satellites (with their Desktop Stands attached) may be installed in their floor stands.
1. Two of the six floor stand legs |
have a full length slot, with short |
notches opposite the slot at each |
end. The slot allows the satellite |
cable to be concealed. Insert a |
satellite cable inside one of these |
legs by feeding it down the length |
of the full length slot. At each |
end, feed the cable through the |
short notches (see Diagram M). |
2. Insert the satellite end of the leg/ |
cable assembly into the middle |
socket of the apex joint. Make |
sure the satellite cable exits |
through the short notch and |
not the full length slot (see |
Diagram N). |
3. Insert the two solid legs into the |
The front of the slot is the side further away from the rear leg socket. Make sure the stand is securely pressed into the slot.
5.At the base of the rear leg, gently pull on the satellite cable to remove any unnecessary slack in the cable.
6.Insert a rubber plug into the base of each leg, taking care to feed the cable out the short notch in the rear leg (see Diagram O).
Screw Mounting: The Satellite and Center Channel speakers may be hung on a wall using a No.10 screw and their keyhole openings.
First attach four
Plastic anchors may be needed to secure the screws into particu- larly hard or soft material. If so, drill the appropriate sized holes in the wall and tap the anchors into the holes until they are flush with the wall. Insert the screws into the anchors until they protrude 3/8 inch from the wall.
outside sockets in the apex joint. |
4. Slide the back edge of the |
satellite’s desktop stand into the |
front of the slot in the apex joint |
(be sure there are no feet attached |
to the base of the desktop stand). |
M
O
N
P
7