Cambridge SoundWorks Speaker System manual Making Connections, Placement, Decoder Amplifier

Hook and Loop Fasteners: When mounting speakers with hook and loop fasteners, make sure that all surfaces are clean and free of dirt and grease. Hard, flat, unpainted surfaces work best with hook and loop fasteners (see Diagram Q).

Attach the fastener to the speaker first, remove the backing and adhere to the chosen surface.

Q

Decoder Amplifier			Making Connections
Placement			on the next page before making	stereo miniplugs at each end to
			Consult the Wiring Diagram	Use the signal cable with black
	The Decoder Amplifier can be placed		any connections.	connect the rear output of your
on the desktop, a shelf or any site that			Speaker Connections. Insert	sound card (if present) to the
makes the controls convenient.			one satellite’s plug into the	REAR INPUT of the Decoder
	The Power Adapter cord must be		corresponding Speaker Output on	Amplifier.
able to reach from the Decoder			the Decoder Amplifier. Repeat	Power Supply Adapter Connec-
Amplifier back panel to your AC			this process for the remaining	tions. Confirm the power switch is
power receptacle.			satellites and subwoofer.	in the “OFF” position. Insert the
	Place the Decoder Amplifier on a		Signal Connections. Connect	power supply’s AC plug into an
hard, flat surface.				appropriate receptacle. Insert the
			the Dolby Digital/SPDIF output of
	There are ventilation slots on the			small DC connector into the “15V
			your signal source to the Decoder
bottom and top of the Decoder				DC IN” receptacle on the back of
			Amplifier using the cable with
Amplifier’s enclosure. Don’t block the				the Decoder Amplifier.
			RCA plugs at each end.
ventilation slots by placing material on
			Use the signal cable with green
top of or below the Decoder Amplifier.
			stereo miniplugs at each end to
			connect the stereo line output of
		R	your sound card to the LINE IN
			input of the Decoder Amplifier.

8