Weber 55548 manual Check for gas leaks

Page 20

Gas Instructions

Check for gas leaks

￿DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion which can cause serious bodily injury or death and damage to property.

￿WARNING: You should check for gas leaks every

time you disconnect and reconnect a gas fitting.

Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame- tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber® gas barbecue. Shipping and handling may loosen or damage a gas fitting.

￿WARNING: Perform these leak checks even if your barbecue was dealer or store assembled.

You will need: a soap and water solution, and a rag or brush to apply it.

To perform leak checks: Slide back the collar of the quick disconnect. Push male fitting of the hose into the quick disconnect, and maintain pressure(1). Slide the collar closed(2). If it does not engage or lock, repeat procedure. Gas will not flow unless the quick disconnect is properly engaged.

Turn on gas supply.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows, there is a leak.

Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

￿WARNING: Do not ignite burners when leak checking.

(1)

(2)

Check:

1) Hose to manifold connection.

￿WARNING: If there is a leak a connection(1), re- tighten the fitting with a wrench and recheck for leaks with soap and water solution.

If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your region using the contact information sheet provided with your manual.

2) Valves to manifold connection

￿WARNING: If there is a leak at connections(1) or(2) turn OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in

your region using the contact information sheet provided with your manual.

When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.

(1)

(2)

(3)

*The grill illustrated may have slight differences than the model purchased.

C-3

Image 20
Contents N E S I S Natural Gas Grill Owner’s GuideLiquid Propane GAS Units only Contents Warranty For Installation in Canada General InstructionsCleaning CookingExploded View Exploded View List Parts List Unpacking Ba302.b Page Page B303LP.a Page Page Page Gas Instructions Check that all burner valves are off Check for gas leaks To Extinguish Operating InstructionsLighting Manual Lighting Troubleshooting Problem Check CureMaintenance Annual MaintenanceMain Burner Cleaning Procedure Weber Spider /Insect screensReplacing Main Burners Crossover Ignition System Operations