4)Switch the appliance on with the on/off switch 3. The rotary switch 5 must
be in the position “”. The steam control knob 2 is closed.
5)Insert the sieve carrier w, WITHOUT espresso powder, into the appliance and place a cup under the sieve carrier w. As soon as the green
control lamp 4 glows, turn the rotary switch 5 to the position “ ”.
6)Allow about 2 cups of water to pass through and then stop the process.
7)Hold a container under the milk frother z.
8)Place the rotary switch 5 at the position “steam” and wait until the green
9)After 2 minutes close the steam control knob 2, set the rotary switch 5 to the
position “” and switch the appliance off.
10)Let the scaling agent take effect for about 15 minutes.
11)Repeat the steps 4 - 10 three times.
12)Then place the rotary switch 5 at the position “ ” and let the solution flow through until the water tank 1 is empty.
13)Rinse the water tank 1 with clean water and then fill it with clean water up to the Max marking.
14)Turn the rotary switch 5 to the position “ ” as soon as the green heating- up control lamp 4 glows.
15)Allow the water to run through.
16)Repeat the steps 13 - 15 three times.
17)Fill the water tank 1 with water once again.
18)Turn the rotary switch 5 to the position “ ”.
19)Hold a container under the milk frother z and slowly rotate the steam control knob 2 to the position “+” as soon as the green
20)After about 1 minute close the steam control knob 2, set the rotary switch 5
to the position “” and switch the appliance off.
GB
IE
Espresso Machine | 17 |