Getting Started
Power Up the System
Use the power button on the receiver or on its remote control to turn on the receiver. If the display reads “ANTENNA” after powering up, check that the antenna connection is secure and completely pushed in. Next, change channels (from 0 to 1 or from 1 to 0 if the receiver is not authorized yet).
NOTE: Some receivers will power up automatically when installed in the Delphi Premium Sound System.
If the “ANTENNA” message remains, power down the radio, unplug the antenna and look for any obvious damage in the connector, jack or antenna cable. If no damage is detected, reconnect the antenna, turn the unit back on, and change channels again. If the message still appears, contact your retailer.
If the display reads “NO SIGNAL” after powering up, follow the instructions in “Setting up the Antenna” on page 5.