Audiovox manual Cabling Interconnections, Installing the Shuttle in the SIR-BB1

BATTERY	BATTERY COMPARTMENT	BOTTOM OF
COMPARTMENT	COVER LATCHES
		BOOM BOX
COVER

1.Turn the Boom Box upside down to access the battery compartment.

2.Push the battery cover latches forward and flip up the battery compartment cover to the open position.

3.Insert eight (8) D-Cell batteries observing battery polarity as shown; then close the cover.

POSITIVE	NEGATIVE
BATTERY
COMPARTMENT
(COVER REMOVED)
NEGATIVE	POSITIVE

2.Cabling Interconnections

You can begin to enjoy Sirius® Satellite Radio as soon as the Shuttle and Boom Box Kit installation are complete. Set up your Audiovox SIR-BB1 by following the interconnect diagram.

3.Installing the Shuttle in the SIR-BB1

Place the Shuttle in the cradle so that the Shuttle guides are lined up with the SIR-BB1 cradle. Then push the Shuttle forward to engage the connectors. The Shuttle will snap into place. Apply power to the SIR-BB1 by rotating the VOL control clockwise from the off position; the LED indicator lights green. If the Shuttle does not turn on at the same time, press the red Power On/Off button in the upper left corner of the Shuttle front panel.

4.Removing the Shuttle From the SIR-BB1

Press and hold the eject button on top of the Boom Box; the

Shuttle will partially eject forward. Using your thumb and forefinger, grasp the Shuttle on the sides and pull forward to disengage.

-6-

128-6945

6 of 12