Audiovox manual Boom Box SIR-BB1 Controls, Battery Installation

Page 5

Boom Box SIR-BB1 Controls

The Audiovox Sirius® Boom Box SIR-BB1 provides two control buttons, a Power On/Off -Volume control, and a pushbutton to toggle between Satellite Radio or an auxiliary audio input signal. A power-on LED is also located on the front panel.

1.PHONES Jack: Accepts a stereo headphone jack to provide private listening capability for the Boom Box.

2.SRS/AUX Selector Pushbutton: Pushbutton toggles between Satellite Radio and an external audio input signal (MP3, CD, etc.) present at the AUX input jack.

3.AUX Jack: Accepts an audio input signal from

an external audio device. When

6

 

using the AUX audio

 

AUDIO OX

 

 

 

 

input, turn the Shuttle

 

 

 

off to preserve battery

 

 

 

power. Adjust the

 

 

 

volume level of the

 

 

 

external audio device 1

2

3 4

5

to obtain an audio output from the SIR-BB1. The volume control on the external audio device should be set to mid-range.

4.Power On/Low Battery LED: The LED lights green when the Power On/Off Switch-VOL control is rotated clockwise (CW) to the On position. In addition, the LED will light red to alert the user that the batteries are nearly discharged. This condition may cause degraded performance of the SIR-BB1.

5.Power On/Off Switch-VOL Control: Applies power to the Boom Box when rotated clockwise (CW) from the Off position. When in On position, increases or decreases the volume of the audio output signal from the SIR-BB1. To increase the volume level, rotate the control CW. To decrease the volume level, rotate the control counterclockwise (CCW).

6.Release Button: Press this button to release and remove the Shuttle from the SIR-BB1 cradle.

1.Battery Installation

Your Boom Box can operate independently of AC power by installing 8 D-Cell batteries as follows:

NOTE: The batteries are bypassed automatically whenever the supplied AC Adapter is plugged into the DC 12V jack on the back panel.

-5-

128-6945

5 of 12

Image 5
Contents Shuttle Boom BOX Congratulations FCC Regulations Setting Up and Installing Your Kit Contents SIR-BB1Installation/Wiring Precautions Boom Box SIR-BB1 Controls Battery InstallationRemoving the Shuttle From the SIR-BB1 Installing the Shuttle in the SIR-BB1Cabling Interconnections Installing/Positioning the Antenna Interconnect DiagramAntenna Placement Considerations Specifications Periodic Inspection MaintenanceCleaning the SIR-BB1 Boom Box Fault Prob AB L E Remedy Cause TroubleshootingMonth Limited Warranty