AirLink MP595 / MP595W Modem User Guide
Connector panel
The MP 595 modem has the following connectors:
|
|
|
|
| AP antenna for wireless | |
|
| GPS antenna (female SMA) | access point (MP595 only) | |||
USB (Type B) |
| Ethernet | I/O connector (DB15HD) | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Serial Host | USB Host | GPS Ethernet Host | AP | I/O |
|
|
| ||
Diversity | Main RF |
|
| Power |
|
|
|
|
|
Diversity antenna (SMA)
Note: Electrical installations are potentially dangerous and should be performed by personnel thoroughly trained in safe electrical wiring procedures for vehicles.
Power harness (Molex connector)
Main RF antenna (female TNC)
Figure
GPS and I/O options
The MP modem provides support for GPS (Global Positioning System) and for attaching input/output devices.
GPS. If you plan to use the MP modem’s built‐in GPS module, you must connect a GPS antenna using an antenna cable, or use a combination antenna that can connect to both the GPS and Main RF connectors on the MP modem housing.
Other I/O devices. Other devices, such as panic buttons, sensors, or gauges may also be installed with the MP modem and connected with an I/O cable to the I/O port. (See “I/O port connections” on page 37.)
Overview of installation steps
The installation process for the MP modem varies depending on how you plan to use it, where it best fits, and which of its features you plan to use. The main steps are:
1.Mount the MP modem.
2.Mount the antennas and connect the cables.
·Main RF antenna and cable
·Additional RF antenna and cable, if you plan to use receive diversity.
·GPS antenna and cable, if you plan to use GPS
·AP antenna and cable (MP 595W only)
3.Connect the power harness.
|
|
|
|
|
|
|
26 |
|
|
|
|
| 2130795 |
|
|
|
