English
Features
This appliance includes some or all of the following features (fig. A).
1.Lid
2.Sieve control
3.Spout
4.Upper Reamer
5.Lower Reamer
6.Handle
7.Jug
8.Base
9.Viewing window
10.Upper sieve
11.Lower sieve
12.Spindle
Assembly (See Figures D & E)
This appliance is supplied fully assembled & only requires parts to be cleaned before use.
See “Cleaning” for details.
Fit the jug (7) onto the base (8) & rotate the jug in a
Place the lower sieve (11) into the jug, with the sieve control (2) located in the recess in the jug.
Fit the upper sieve (10) by first locating the tab into the slot in the lower sieve.
Place the lower reamer (5) over the spindle (12) and push it down so it snaps into position in the lower reamer.
When required, the upper reamer (4) can be positioned on top of the lower reamer. The 2 recesses in the upper reamer must fit over the tabs of the lower reamer.
Use (See Figures B & C)
Prepare the fruit by rolling it gently between the hands for a moment or two then cut it in half.
Push the sieve control to the right to open the sieve. This will allow the juice to flow into the jug below. At the fully open position, some pieces of the fruit may also fall into the jug. The gap can be varied as required.
Connect the appliance to a suitable electrical supply.
Press the cut face onto the reamer. Pressing on the reamer will start the motor in the base. The reamer will rotate, cutting into the fruit and the juice will flow into the jug.
Note: Ensure fingers & hands do not touch the reamer during operation. Never allow loose clothing, jewellery, hair, etc. to come in contact with moving parts.
The amount of juice in the jug can be viewed through the window (9).
Once juicing is completed, the lid (1) can be placed over the unit.
The jug can be removed & used to serve the juice.
Note: Do not run the appliance for more than 10 times continuously. After 3 minutes of continuous use, allow the appliance to cool for 15s before further usage.
Maintenance
Your Black & Decker tool has been designed to operate over a long period of time with a minimum of maintenance. Continuous satisfactory operation depends upon proper tool care and regular cleaning.
Warning! Before performing any maintenance or cleaning of the tool, disconnect the appliance from the power supply.
Ventilation slots should be cleaned occasionally with a clean, dry paint brush.
Cleaning
Lift the lid (1) and outer reamer (5) from the jug then remove the lower reamer (4) and upper sieve assembly. These parts are loosely fastened together
&can be separated to facilitate cleaning. The lower sieve can also be removed.
The jug (7) can be removed from the base by rotating it in an
The base (8) should be cleaned with a clean damp cloth only & dried thoroughly before
All other parts should be washed in warm soapy water. Rinse with clean water and dry thoroughly with a dry soft cloth.
Note: Do not use abrasives or chemical cleaners on any part of this appliance.
Technical data |
| LCJ82 |
Voltage | V | |
Power input | W | 60 |
Cable length | m | 1.0 |
Container size | l | 1.9 |
Weight | kg | 1.4 |
|
|
|