Bush Hog GHM 700, GHM 1900, GHM 1800, GHM 900, GHM 800 manual Transport Lock

D. Attach PTO driveline to tractor 540 rpm or 1000 rpm PTO shaft. Make certain driveline is securely connected at both ends. Attach PTO drive- line shield safety chain on both the implement and tractor ends. (Figure 2-3)

CAUTION

DO NOT USE A PTO SHAFT ADAPTER WITH THIS IMPLEMENT. USE OF A PTO SHAFT ADAPTER WILL VOID ALL WARRANTY CONSIDERATIONS.

E. Pin parking stand in work position. (Figure 2-4) F. Adjust tractor lower lift arms so vertical main

frame is perpendicular to the ground as shown in Figure 2-5.

G. Set tractor 3-point hitch depth control or install the optional check chain assembly to stop with the horizontal main frame pivot approximately 20 inches from the ground. (Figure 2-4)

Figure 2-3

Fasten Shield Safety

Chains At Each End

Figure 2-4

20”

Parking Stand Stored

Ground

H. Check to be certain all persons are clear of cutter bar.

I.Raise mower using tractor 3-point lift. Raise cutter bar to transport position. When cylinder “bot- toms out” hold valve open an additional 3-5 seconds to purge air from system.

J.Pin transport lock to retain cutter bar in the transport position. (Figure 2-6)

Figure 2-5

90°

Ground

Figure 2-6 Transport Lock

9