Antex electronic TriplePlay Multizone Satellite Audio Receiver warranty Antex Electronics

2 Antex Electronics

Antex Electronics Corporation

1125 W. 190th Street

Gardena, California 90248

USA

www.antex.com

Copyright © 2003 Antex Electronics Corporation. All Rights Reserved. No portion of this manual may be reproduced without prior written consent from Antex Electronics. The copyright protection claimed here includes photocopying, translation, and/or reformatting of the information contained in this manual.

Printed in the United States of America.

Document No.: 9000-2467-7006 Rev. A

FCC Compliance Statement for United States Users

This equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non- approved equipment or unshielded cables is likely to result in interference to radio and TV reception. Changes or modifications made to this equipment not expressly approved by Antex Electronics could void the user’s authority to operate the equipment.

IMPORTANT SAFETY INSTRUCTIONS

?Read Instructions – Read all Safety Instructions before operating equipment.

?Retain Instructions – Save these instructions for future reference.

?Heed Warnings – All warnings on the product and these instructions should be adhered to.

?Follow Instructions – All operating and use instructions should be followed.

?Cleaning –Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.

?Attachments – Do not use attachments not recommended by the manufacturer as they may cause hazards.

?Water and Moisture – Do not use this product near water – for example near a bathtub, wash bowl, kitchen sink or a room where moisture is likely to occur.

?Accessories – Do not place on an unstable surface (cart table or tripod) where tipping is a possibility.

?Ventilation – Install unit in well ventilated area where self generated heat may escape. Book cases or cabinets should have proper venting to allow heat to escape.

?Power outlet – A properly grounded wall outlet must be used. Do not use a plug adapter that bypasses the three- terminal ground plug.

?Power Cord Protection – Route your power cords out of traffics way so as not to be walked on or traveled over by carts wheels. Do not place items on top of or against the cord so as to pinch the cord.

?Outdoor Antenna Grounding – The antenna and coaxial cable connecting to the unit must be properly grounded to prov ide some protection against voltage surges and built - up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead -in wire to a antenna discharge unit, size of grounding conductors, location of antenna- discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

?Power Lines – An outside antenna system should not be located in the vicinity of overhead power lines or electric light or power circuits, or where they can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

?Overloading – Do not overload wall outlets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electrical shock.

?Object and Liquid Entry – Never push objects of any kind into this product through openings as they may short- out parts that could cause a fire. Never spill liquid of any kind on the product.

?Servicing – Do not attempt to service this product yourself, there are no customer serviceable parts inside. Refer all servicing to qualified service personnel.

A product and cart combination should be moved with care. Quick stops, excessive force, and uneven surfaces may cause the product and cart combination to overturn.

?Damage Requiring Service – Unplug this product from the wall outlet and refe r servicing to a qualified service person under the following conditions:

a)When the power-supply cord or plug is damaged.

b)If liquid has been spilled, or objects have fallen into the product.

c)If product has been exposed to rain or water.

d)If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation.

e)If the product has been dropped or damaged in any way.

f) When the product exhibits a distinct change in performance – this indicates a need for service.

?Replacement Parts – When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorized substitutions may result in fire, shock, or other hazards.

?Safety Check – Upon completion o f any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

?Heat – The product shall be situated away sources such as radiators, heat resistors, heat registers, stoves, or amplifier that produce heat.

© 2003 Antex Electronics, Inc.