SPECIAL APPLICATION
Cause 4: Video equalization required.
Solution: Adjust the VIDEO EQUALIZATION
on the
may require adjustment on both the
In general, cable runs less then 50 ft (15 m) require little or no video equalization and should be set to minimum. Cable runs up to 400 ft (122 m) will require near maximum equalization on both the transmitter and receiver.
Cause 5: The display has a problem.
Solution: Make sure the display is powered and is turned on. If there is still no display, please call ALTINEX at
(714)
8.2NO SOUND
Cause 1: The source has a problem.
Solution: Check the source and make sure that there is a signal present and all source connections are correct. If the source is working and there is still no sound, see Cause 2.
Cause 2: The volume is too low.
Solution: Increase the gain at the source toward maximum. If there is still no sound present, see Cause 3.
Cause 3: Cable connections are incorrect.
Solution: Make sure that cables are properly connected. Also, make sure that the continuity and wiring are good. If there is still no sound, see Cause 4.
Cause 4: The receiving device has a problem.
Solution: Make sure the receiving device is powered and is turned on. If there is still no sound, please call ALTINEX at (714)
ALTINEX POLICIES | 9 |
9.1 LIMITED WARRANTY/RETURN POLICIES
Please see the ALTINEX website at www.altinex.com for details on warranty and return policies.
9.2CONTACT INFORMATION ALTINEX, Inc.
592 Apollo Street
Brea, CA 92821 USA
TEL: 714
TOLL FREE:
WEB: www.altinex.com
8 |