SPECIAL APPLICATION
INSTALLING YOUR | 6 |
Step 1. Determine the best location for the
Step 2. Apply power to the
Step 3. Connect the video source to the input of the
Step 4. The Power LED should change from red to green indicating a signal is present.
Step 5. Connect the audio input source to the audio jack on the
Step 6. Run a
NOTE: Ensure good signal transmission by routing the cable avoiding any sharp angles, creases, or bends.
Step 7. Connect the
outputs to their receiving devices.
NOTE: The L+, L- and GND outputs on the
Step 8. Apply power to the
Step 9. The units are now operational.
OPERATION | 7 |
The
7.1 VIDEO EQUALIZATION
Video equalization is provided to
The equalization adjustment on the
TROUBLESHOOTING GUIDE | 8 |
We have carefully tested and have found no problems in the supplied
8.1 NO DISPLAY
Cause 1: The source has a problem.
Solution: Check the source and make sure there is a signal present and all source connections are correct. If the source is working and there is still no display, see Cause 2.
Cause 2: The path has a problem.
Solution: Connect the transmitter directly to the receiver using a short
Cause 3: Cable connections are incorrect.
Solution: Make sure the cables are properly connected. Also, make sure that the continuity and wiring are good. If there is still no display present, see Cause 4.
7 |