Black & Decker FP2500SC, FP2500C manual Arugula Pesto, Pastry Crust

ARUGULA PESTO

2 cups packed fresh arugula leaves

1 cup packed basil leaves

½cup packed Italian parsley leaves

½cup grated Parmesan cheese

½cup pine nuts (pignoli)

2 large cloves garlic, minced

1 teaspoon grated lemon peel ¾ cup olive oil

Place all ingredients, except oil in workbowl Black & Decker® Food Processor fitted with cutting blade. Cover and process on HIGH until smooth, about 1 minute. Stop occasionally to scrape down sides of bowl. Remove pusher from feed chute and drizzle oil in an even stream into processor. Continue to process until mixture is smooth.

Makes about 1½ cups.

Note: If desired, substitute 2 cups packed baby spinach leaves for arugula.

PASTRY CRUST

1 cup unsifted all-purpose flour ½ tsp. salt

¼ cup shortening

2 tbsp. cold butter or margarine, cut into small pieces 2 to 4 tbsp. ice water

Position metal blade in workbowl of Black & Decker® Food Processor. Add flour, salt, shortening and butter. PULSE 3 or 4 times, for about 3 to 4 seconds each, until mixture is crumbly.

With processor running, drizzle in just enough water through the small feed chute until mixture pulls away from sides of bowl and forms a loose ball.

Remove workbowl from processor; remove blade. Turn dough out onto lightly floured work surface. Gently shape dough into ball. Wrap in plastic wrap and refrigerate for at least 20 minutes. (If storing longer, allow dough to rest on work surface for 15 minutes before rolling out.) Roll out to a circle 2 inches larger than the inverted pie plate to be used.

Transfer pastry to pie plate. To bake empty, pierce generously with fork. Bake at 425˚F (218˚C) until golden, about 12 minutes.

Makes one, 9-inch (23 cm) pie crust.

TROUBLESHOOTING

PROBLEM	POSSIBLE CAUSE	SOLUTION
Food is unevenly	Workbowl is overfilled.	Smaller amounts will
chopped.	You may be running	process more evenly.
	the bowl continuously	Use the PULSE (P) button
	instead of on PULSE.	in 5-second or less
	Food may be cut in	increments. Allow the
	random sizes.	blades to stop completely
		before pressing the
		PULSE (P) button again.
		Cut food in same size
		pieces before placing in
		processor.
Liquid leaks from the	Too much liquid in the	Process smaller amounts.
bottom of the workbowl.	workbowl.	When processing liquids,
		do not add more than
		3 cups to workbowl.
		Do not remove the
		blade before removing
		workbowl from processor
		when processing liquids.
Sliced foods are uneven	The feed chute has not	Cut pieces in even
and slanted.	been well packed or	lengths, just a little
	uneven pressure has	shorter than the length
	been applied to the food	of the feed chute. Pack
	pusher during processing.	the chute carefully and
		maintain even pressure
		on the food pusher as the
		food is being processed.
Foods being sliced or	This is normal.	Stop processing
shredded fill up on one		occasionally and either
side of the bowl.		even out the food in the
		workbowl or move it to
		another bowl. When food
		accumulates close to the
		disc, empty the workbowl
		before continuing.

13 14