Whirlpool 9763375 Install Range Hood, Install Vent for vented installations only

Install Range Hood

WARNING

Excessive Weight Hazard

Use two or more people to move and install range hood. Failure to do so can result in back or other injury.

1.Hang hood on 2 mounting hooks through the rectangular cutouts on back of hood.

A B

D

B C

A, Mounting hooks

B. Mounting screws

C. Leveling screws

D. Centerline on wall

2.Level the hood with leveling screws in mounting hooks or rectangular cutouts, using a level across bottom of hood.

3.Secure hood with 4 screws through remaining 4 holes in hood.

Install Vent (for vented installations only)

1.Fit vent system over transition piece.

A

A.Transition

2.Seal connection with duct tape.

Make Electrical Connection

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Disconnect power.

2.Remove terminal box cover.

3.Remove the knockout in terminal box cover and install the UL-or CSA-listed ¹⁄₂" conduit.

4.Run 3 wires, black, white and green (14AWG) in ¹⁄₂" conduit from service panel to terminal box.

A

A.Conduit

5.Use twist-on connectors and connect black wires together.

6.Use twist-on connectors and connect white wires together.

WARNING

Electrical Shock Hazard

Electrically ground blower.

Connect ground wire to green and yellow ground wire in terminal box.

Failure to do so can result in death or electrical shock.

7.Use twist-on connectors and connect green or bare wire with yellow-green wire.

8.Replace terminal box cover.

9.Check all light bulbs to make sure they are secure in their sockets.

10.Reconnect power.

8