Safety, Key Processor, Liquidiser | Kenwood FP905, FP920, FP910

safety

● The blades and discs are very sharp, handle

with care. Always hold the knife blade

by the finger grip at the top, away from the cutting edge, both when handling and cleaning.

●Do not lift or carry the processor by the handle - or the handle may break resulting in injury.

●Always remove the knife blade before pouring contents from the bowl.

●Keep hands and utensils out of the processor bowl and liquidiser jug whilst connected to the power supply.

●Switch off and unplug:

●before fitting or removing parts

●after use

●before cleaning

●Never use your fingers to push food down the feed tube. Always use the pusher/s supplied.

●Before removing the lid from the bowl or liquidiser/mill from the power unit:-

●switch off;

●wait until the attachment/blades have completely stopped;

●be careful not to unscrew the liquidiser jug or mill from the blade unit.

●Do not use the lid to operate the processor, always use the on/off speed control.

●This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.

●Never use an unauthorised attachment.

●Never leave the machine on unattended.

●Never use a damaged machine. Get it checked or repaired: see ‘service’.

●Never let the power unit, cord or plug get wet.

●Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.

●Do not exceed the maximum capacities stated.

●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

●Children should be supervised to ensure that they do not play with the appliance.

●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

●Misuse of your processor/liquidiser can result in injury. before plugging in

●Make sure your electricity supply is the same as the one shown on the underside of your machine.

Important – UK only

●The wires in the cord are coloured as follows: Green and Yellow = Earth,

Blue = Neutral, Brown = Live.

●The appliance must be protected by a 13A approved (BS1362) fuse.

●WARNING: THIS APPLIANCE MUST BE EARTHED.

Note:

●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable pug is inadvertently inserted into a 13A socket outlet.

●This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.

before using for the first time

1Remove all packaging including the plastic blade covers from the knife blade. Take care the blades are very sharp. These covers should be discarded as they are to protect the blade during manufacture and transit only.

2Wash the parts see ‘cleaning’

3Push excess cord into the back of the machine.

key

processor

power unit detachable drive shaft bowl

lid

feed tube pushers safety interlocks cord storage

speed control with power on light

liquidiser

filler cap lid

lid seal (FP920/FP930)

jug – plastic (FP910) & Glass (FP920/FP930) sealing ring

blade unit

additional attachments

Not all of these attachments listed below will be included with your food processor. To buy an attachment not included in your pack, contact the dealer from whom you purchased your appliance.

knife blade dough tool

twin beater geared metal whisk maxi-blend canopy

thick slicing/coarse shredding disc thin slicing/fine shredding disc

fine (Julienne style) chipper disc (FP920/FP930) rasping disc (FP920/FP930)

geared citrus press mill (FP920/FP930)

mini processor bowl (FP920/FP930) centrifugal juicer (FP920/FP930)

KENSTORE™ attachments carousel (FP920/FP930) recipe book

spatula

FP905, FP930, FP910, FP920 specifications

The Kenwood FP920, FP910, FP930, and FP905 are part of a renowned line of food processors that feature advanced technology and innovative design, making them essential kitchen appliances for both amateur cooks and culinary enthusiasts.

The FP920 model boasts a powerful motor that provides efficient processing for a variety of tasks, from chopping vegetables to kneading dough. Its generous bowl capacity allows for handling large quantities of ingredients, making it an ideal choice for families or those who entertain frequently. The design includes an easy-to-use control panel with multiple speed settings, allowing for precise control over food preparation and achieving the desired texture.

In the FP910, Kenwood has enhanced the user experience with additional features like an integrated citrus juicer and a wider range of attachments, including slicing and grating discs. This model emphasizes versatility, enabling users to easily switch between functions without needing multiple appliances. The compact design ensures that it fits well on kitchen countertops without taking up too much space.

The FP930 takes functionality a step further with a digital interface that simplifies operation. This model comes equipped with a powerful motor and a variety of safety features, including a locking lid and non-slip feet for enhanced stability during use. The FP930 also offers a greater range of bowl sizes, allowing users to select the best fit for their specific tasks.

Finally, the FP905 offers a more budget-friendly option without compromising on quality. It still features a robust motor and a selection of essential attachments, perfect for daily food prep needs. The FP905 is designed for ease of use, featuring dishwasher-safe parts for easy cleaning and maintenance.

All four models share core technologies that enhance user experience. The patented multi-tool system allows for seamless switching between different attachments, and the machines are built with durable materials that ensure longevity. Easy assembly and disassembly make them user-friendly, while their compact design makes storage convenient.

In conclusion, Kenwood’s FP920, FP910, FP930, and FP905 provide a range of features and technologies that cater to various cooking needs. Each model blends power, versatility, and design, making them valuable additions to any kitchen.