Troubleshooting, To fit and use your splashguard

KENWOOD CHEF AND MAJOR KM010 - KM020 series

troubleshooting

problem

●The whisk or K-beater knocks against the bottom of the bowl or isn’t reaching the ingredients in the bottom of the bowl.

solution ● Adjust the height. Here’s how:

1 Unplug.

2 Raise the mixer head and insert the whisk or beater.

3Hold it, then loosen the nut

4Lower the mixer head.

5Adjust the height by turning the shaft. Ideally the whisk/K-beater should be almost touching the bottom of the bowl

6Raise the head, hold the whisk/K-beater and tighten the nut.

problem

●The mixer stops during operation.

solution ● Your mixer is fitted with an overload protection device and will stop if overloaded to protect the machine. If this happens, switch off and unplug the mixer. Remove some of the ingredients to reduce the load, and allow the mixer to stand for a few minutes. Plug in and reselect the speed. If the mixer does not restart immediately allow to stand for additional time.

to fit and use your splashguard

1Raise the mixer head until it locks.

2Fit the bowl onto the base.

3	Push the splashguard onto the underside of the mixer head	until fully
	located. The hinged section should be positioned as shown.
4	Insert required tool.
5	Lower the mixer head.

●During mixing, ingredients can be added directly to the bowl via the

hinged section of the splashguard

CHEF

●You do not need to remove the splashguard to change tools.

6Remove the splashguard by raising the mixer head and sliding it down.

min

in m