Safety, Key, To use your handmixer

before using your Kenwood appliance

●Read these instructions carefully and retain for future reference.

●Remove all packaging and any labels.

safety

●Ensure the cord is fully unwound from the cord wrap before using the handmixer.

●Never put the handmixer body in water or let the cord or plug get wet.

●Keep fingers, hair, clothing and utensils away from moving parts.

●Never let the cord touch hot surfaces or hang down where a child could grab it.

●Never use a damaged handmixer. Get it checked or repaired: see 'service and customer care'.

●Never use an unauthorised attachment.

●Always unplug the appliance when not in use, before fitting or removing parts or before cleaning.

●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

●Children should be supervised to ensure that they do not play with the appliance.

●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

before plugging in

●Make sure your electricity supply is the same as the one shown on the underside of your handmixer.

Important – UK only

●The wires in the cord are coloured as follows: Blue = Neutral, Brown = Live.

●The appliance must be protected by a 5A approved (BS1362) fuse.

Note:

●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.

●This handmixer complies with European Economic Community Directive 89/336/EEC.

before using your handmixer for the first time

●Wash the parts (see 'cleaning').

key

speed switch

tool release button beaters

cord wrap

kneader with additional collar kneader without additional collar beater storage pillars kneader storage pillars worktop storage unit

cord clip

to use your handmixer

1Unwrap the cord from the cord wrap and make sure the speed switch is in the off position by lining up the O symbol on the handmixer body with the dot on the side of the speed switch. Insert the beaters or kneaders – turn and push until a positive click is felt. The tabs on the tool shafts need to line up with the outlet holes. Important: The kneader with the additional collar will only fit into the larger outlet hole.

2Plug in.

3With the ingredients in a suitably sized bowl, place the beaters/kneaders into the bowl.

4Pull the speed switch backwards to reach the desired speed (the first dot on the handmixer body is slow and speed 5 is fast). Line up the dot on the side of the speed switch with the corresponding speed.

●As the mixture thickens, increase the speed.

●If the machine labours increase the speed.

●Move the speed switch forwards to the pulse position

(P) to operate the motor as required. The motor will operate for as long as the pulse is held in position.

5When the mixture has reached the desired consistency, return the speed switch to the off position and then lift the beaters/kneaders out of the bowl.