Nuvo NV-T2DF manual IR Pass-Thru, Using the Aux. Input

IR Pass-Thru

The mini jack labeled “IR pass-thru" mini connection is used for connecting forwarded IR signals to an audio component connected to the auxiliary audio input.

Using the Aux. Input

The T2 is equipped with an auxiliary audio input labeled “AUX IN.” This will accept an audio signal from an external component. This is most useful as an additional local source, or an additional source in a multi-zone audio system.

The auxiliary input is a stereo RCA connection and requires a standard RCA cable for the connection, fig. 4. This must be enabled through the advanced menu, which is accessed through the “Select Knob” on the face of the T2 (see Menu Controls, AUX Input pg. 14) or in the T2 Configurator software (see Using the T2 Configurator Software pg. 22). An additional advanced feature is the ability to set the gain of the auxiliary signal to match the output signal level of the T2.

Once the auxiliary input is enabled, it is selected from the remote using the “AUX” button, fig. 5, or by pressing the “Source” button for either Tuner A or Tuner B on the face of the T2 and stepping through FM, AM, and WX (Weather Band) to Aux., fig. 6.

Fig . 4

Auxiliary

Audio Source			Audio
			Out
AUX IN	OUT	AUX IN	OUT
USE ONLY NuVo	TRIGGE		TRIGGER
NV-T2PAS		L
POWERED ANTENNA SYSTEM	ON=+12		ON=+12V
	AUDIO	R	AUDIO
	OUTPUT		OUTPUT
IN
ANTENNA INPUT	TUNER B		TUNER A

Fig . 5

PWRA/B

TUNER

HOLD

ALL OFF

ENTER

SEEK

TUNE

CATEGORY

SCAN

1	2	3
4	5	6
7	8	9
PRE	0	ENT

DIR

FM	AM
WX	AUX

T2 Tuner

REMOTE CONTROL

Fig . 6

Model NV-T2DF	Tuner A	SELECT	DISPLAY	MEMORY	MENU	PRE/DIR	SOURCE ON-OFF
Dual FM/AM/WX Tuner	Aux Input
REMOTE			CATEGORY		PRESET/DIRECT
STANDBY SENSOR
			<	1	2	3	4	5
	FM STEREO•AM•WEATHER	PUSH TO	<	6	7	8	9	0
		ENTER

Page 9