Safety

before using your Kenwood appliance

●Read these instructions carefully and retain for future reference.

●Remove all packaging and any labels.

● Remove the blade cover .

●Wash all parts - see “care and cleaning”.

general

●Take special care when preparing food for babies, the elderly and infirm. Always ensure that the hand blender shaft is thoroughly sterilised. Use a sterilising solution in accordance with the sterilising solution manufacturers instructions.

●Never touch the blades while the machine’s plugged in.

●Keep fingers, hair, clothing and utensils away from moving parts.

●Unplug after use and before changing attachments.

●Never blend hot oil or fat.

●Never use a damaged hand blender. Get it checked or repaired: see ‘service’.

●Never put the power handle in water or let the cord or plug get wet - you could get an electric shock.

●Never let the cord touch hot surfaces or hang down where a child could grab it.

●Never use an unauthorised attachment.

●Always disconnect the hand blender from the supply if it is left unattended and before assembling, disassembling or cleaning.

●Do not allow children to use the hand blender without supervision.

●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

●Children should be supervised to ensure that they do not play with the appliance.

●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

food processor attachment

●The knife blade and disc are very sharp, handle with care. Always hold the knife blade at the top and disc by the finger grip, away from the cutting edge, both when handling and

cleaning.

●Always remove the knife blade or disc before emptying the bowl.

●Never remove the cover until either the blade or disc has completely stopped.

important

●With heavy mixtures, don’t use your hand blender for longer than 50 seconds in any four minute period - it’ll overheat.

before plugging in

●Make sure your electricity supply is the same as the one shown on the hand blender.

Important - UK only

●The wires in the cord are coloured as follows: Blue = Neutral

Brown = Live.

●The appliance must be protected by a 13A approved (BS1362) fuse.

Note:

●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.

●Your hand blender complies with European Economic Community Directive 89/336/EEC.