Frymaster 1824E manual

Page 2

NOTICE

IF, DURING THE WARRANTY PERIOD, THE CUSTOMER USES A PART FOR THIS ENODIS EQUIPMENT OTHER THAN AN UNMODIFIED NEW OR RECYCLED PART PURCHASED DIRECTLY FROM FRYMASTER DEAN, OR ANY OF ITS AUTHORIZED SERVICE CENTERS, AND/OR THE PART BEING USED IS MODIFIED FROM ITS ORIGINAL CONFIGURATION, THIS WARRANTY WILL BE VOID. FURTHER, FRYMASTER DEAN AND ITS AFFILIATES WILL NOT BE LIABLE FOR ANY CLAIMS, DAMAGES OR EXPENSES INCURRED BY THE CUSTOMER WHICH ARISE DIRECTLY OR INDIRECTLY, IN WHOLE OR IN PART, DUE TO THE INSTALLATION OF ANY MODIFIED PART AND/OR PART RECEIVED FROM AN UNAUTHORIZED SERVICE CENTER.

DANGER

Copper wire suitable for at least 167°F (75°C) must be used for power connections.

DANGER

The electrical power supply for this appliance must be the same as indicated on the

rating and serial number plate located on the inside of the fryer door.

DANGER

This appliance must be connected to the voltage and phase as specified on the rating

and serial number plate located on the inside of the fryer door.

DANGER

All wiring connections for this appliance must be made in accordance with the wiring diagrams furnished with the equipment. Wiring diagrams are located on the inside of the fryer door.

DANGER

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this

or any other appliance.

WARNING

Do not attach accessories to this fryer unless fryer is secured from tipping. Personal

injury may result.

WARNING

Frymaster fryers equipped with legs are for permanent installations. Fryers fitted with legs must be lifted during movement to avoid damage and possible bodily injury. For a moveable or portable installation, Frymaster optional equipment casters must be used.

Questions? Call 1-800-551-8633

WARNING

Do not use water jets to clean this equipment.

DANGER

All wiring connections for this appliance must be made in accordance with the wiring diagrams furnished with the equipment. Wiring diagrams are located on the inside of the fryer door.

WARNING

This equipment is intended for indoor use only. Do not install or operate this

equipment in outdoor areas.

ii

Image 2
Contents Hour Service Hotline 8196115Page Table of Contents General Thermatron CalibrationIdentifying Parts Replace Thermatron Board Replace TransformerReplace Breakers Replace Safety Drain RelayReplace Contactor Replace Thermatron PotentiometerReplace Temperature Sensor and High-Limit Thermostat Probes Replace Heating Elements inside Frypot Replace Frypot Cleaning a Seized PumpReplace Heating Element under the Frypot Page Probe Resistance Chart Probe Resistance ChartProblem Probable Causes Corrective Action Element Wattage/Amperage Calculation ChartsTroubleshooting Control and Heating Problems Fryer repeatedly Filtration Problems Probable Causes Corrective Action Filter pump wontWiring Diagram Accessories Part Number DescriptionCabinetry Backs, Bases, Casters, Sides, Etc E, 12424E Non-FilterItem Part Number Backs, Bases, Casters, Sides, Etc. SCF 22424E and 32424E Item Part Number Door Assembly and Component Parts Part Number Description Flue Caps, Top Caps, and Related Components Item Part Number Control Panels, Wireways, and Related Components Item Part Number Electronic Components Item Part Number Filter Pan Assembly Filter ComponentsFilter Pan Caddy Assembly Item Part Number Under Fryer Filter UFF Components Component Elements and Related Components Harnesses Part Number Description Oil Discharge Assembly 106-2192Oil Return Assembly Drain Valve and Associated Parts Drain and Oil Return Components Standard 1 ½ DrainsComponent Page Wiring Connectors, Pin Terminals and Power Cords Service Hotline