XM Satellite Radio RoadyTM manual Installation

Roady Guide keys 4" x 4" 8/5/03 1:40 PM Page 15

14

Section	Auto-Off
	You can set your radio to automatically shut off 60, 120, or 180 minutes after
	it is turned on. This feature should be used if your vehicle continues to power
	the cigarette lighter/auxiliary power after you remove your key, so if you leave
4	it on, Roady will shut down automatically after the time period you select and
	will not drain your battery.
	TuneSelect™
	Using this function, you can program your Roady to alert you with a tone
	and display change when a favorite song is played again on a channel other
	than the one you are listening to.
	1. While the song is playing, press and hold the Tuning Wheel	in for 2
	seconds. Roady will beep and display “Song Selected” on line 1 of the
	display for 2 seconds, then return to normal display for the current song.
	Up to 10 songs may be stored in the TuneSelect list. Once the list is filled,
	a new entry will replace the oldest item on the list. You can erase songs
	from your TuneSelect list by going into the menu and choosing TuneSelect.
	Then, follow your options to erase specific song titles or clear out all titles.
	2. When the song plays again on any channel other than the one you are
	currently listening to, your Roady will beep and display an alert notice.
	“Song Found” will appear on line 1 and the name of the song on line 2 for

		15
Direct Tune	in. Note: Roady does not have a preview mode when this	Section
Tuning Wheel
This feature changes the functionality of the Tuning Wheel so that it auto-
matically selects a channel each time it is rolled, without having to press
feature is active.		5

Installation

Roady Kit Set-up

Your Roady Kit contains the following components:

Car mount	XM Antenna	12V power adaptor	Cassette audio	Cell phone mount
			adaptor	adaptor

Your kit also includes:

•Car mount bracket • Extra adhesive pad • Surface preparation cleaning kit

•Alcohol prep pad • Cable wrap

Figure 3. Roady Kit components.

5 seconds.
3. While the “Song Found” alert is displayed, push the Tuning Wheel		in to
switch to the channel playing the song. If the Tuning Wheel	is not
pressed while the alert is displayed, TuneSelect will time out and return to
normal display mode.

Hooking up your Roady Receiver

Figure 4. Connect accessories to your Roady Receiver as shown.

Caution: Connect only appropriate input devices to the Roady Receiver. Connecting an incorrect input device may damage the system and/or the external electronic device.

It is recommended that you use only the 12V to 6V conversion power adaptor that came with your Roady Kit.