Jenn-Air JRTD229, JRT219, JRTF2160, JRTF1960, JRT199 manual Temperature before immersing in warm water

Page 18

It is recommended that you disconnect the power cord before cleaning.

Your refrigerator can be rolted out for cleaning. Turn the levelers, at each front corner of the cabinet,counterclockwise untilthey turn freely. Then pullthe cabinet straightout. Note: Ifyou have an Automatic Ice Makerinstalled, we recommend that you turn off the water supply before moving the cabinet.

Aftercleaning behindyour refrigerator, push it backand turn the levelersclockwise until they touch the floor and lock the cabinet in place.

Use mild soap and water, DO NOT use scouring powders, automobile wax, or furniture polish. Rinse with clear water.

Door gaskets may be cleaned with soap and water, a baking soda solution, or mild scouring powder.

Clean both compartmentsand inner door panelswith mild soap and water. Do not use an abrasive powder, solvent, polish cleaner or undiluted detergent.

You may notice a slightdiscoloration appearingat the top and nearthe centerof the back wall of the fresh food compartment. This is no cause for alarm, but it should be cleaned off periodically.

When cleaning a glass cantilever shelf, you can remove it and submerge the entire assemblyinwarm water. Neveruse hot water. Always allow glass to warm up to room

temperature before immersing in warm water.

18

Image 18
Contents MJENN.AIR You follow the instructions carefully 37320-2370Page Models JRT199, JRT219, JRTD229 Rear leveler feet are not requiredModels JRT1960, JRTF1960, JRT2160, JRTF2160 Do not use an adapter plugPage Upper Lower Door Handle Handle Extension Some modelsIs coldest I $ Saves /. ReducesExterior Energy \/ Moisture Page III Page Page Soc k et i n t he side wa ll IIl\\\\\\\\\\. -----------------JPage AR M TueEPage Page Temperature before immersing in warm water FROiT PAN Page Front cabinet surface warm to touch Refrigerator runs too longCabinet vibrates Moisture on outside surfacePage If You Need Service