Metra Electronics 95-7801 installation instructions Honda Civic, Fig. C

95-7801 DASH DISASSEMBLY

HONDA ACCORD 1998-2002

1Disconnect the negative battery terminal to pre- vent an accidental short circuit.

2Unsnap the clock panel, disconnect the wiring and remove. Remove (1) Phillips screw exposed in the clock cavity. Remove (2) Phillips screws below the factory head unit. Unclip the radio trim bezel and disconnect the wiring. Remove

(4)Phillips screws securing the factory head unit assembly and disconnect the wiring. Remove (2) screws securing the factory pocket to the assembly. (Fig. A)

3Cut and remove the mounting tabs from the bot- tom of the Rear Support Tray (Fig. A). Cut and remove the slots on the bottom of the ISO Brackets (Fig. B). Locate tabs "A" on the ISO Brackets for mounting, cut and remove tabs "B"(Fig. C). Cut and remove all mounting clips on the Radio Housing. (Fig. B)

Skip to step #3b on Page 10.

A

B

Fig. A

Fig. B

"A"

Fig. C

HONDA CIVIC 1999-2000

1Disconnect the negative battery terminal to pre- vent an accidental short circuit.

2Remove (2) Phillips screws from the bottom edge of the glove box door and remove the door. Remove (3) Phillips screws from the lower steer- ing column panel. Pull straight down on the lower steering column panel and remove the panel. Remove (2) Phillips screws under the cli- mate controls. Remove (4) Phillips screws from the lower dash location. Remove (4) Phillips screws securing the bottom of the dash trim bezel/head unit assembly and pull the assembly out as far as possible. Cut the zip ties securing the head unit and climate control wires, slide dash trim bezel/head unit assembly from the the dash cavity and disconnect the wiring. (Fig. A)

3Cut and remove all mounting clips on the Radio Housing EXCEPT clips "B" and "H". (Fig. B) Skip to step #3a on Page 9.

A

B"B"

"B"

"H"

"H"

5