Metra Electronics 95-7801 installation instructions Honda Odyssey

95-7801 DASH DISASSEMBLY

HONDA ODYSSEY 1995-1998

ISUZU OASIS 1996-1999

1Disconnect the negative battery terminal to prevent an accidental short circuit.

2Lower the glove box assembly. Remove (2) Phillips screws exposed on the right side of the underdash. Remove (2) Phillips screws from the driver's side knee bolster and (1) Phillips screw in the coin pocket. Remove

(5)Phillips screws from the underdash panel and remove the panel. Remove (4) Phillips screws from the cupholder assem- bly and remove. Remove (2) Phillips screws securing the factory head unit and discon- nect the wiring. (Fig. A)

3Cut and remove all mounting clips on the Radio Housing EXCEPT clips "D" and "H" (Fig. A). Cut and remove the slots on the bottom of the ISO Brackets (Fig. B). (THE

REAR SUPPORT TRAY WILL NOT BE USED). (Fig. B) Skip to step #3b on Page 10.

1 A

B 2Fig. A

"D"
"H"	"D"
Fig. B	"H"

HONDA ODYSSEY 1999-2004

1Disconnect the negative battery terminal to prevent an accidental short circuit.

2Unclip the radio trim bezel (including the climate control panel) and remove). Remove (4) Phillips screws securing the factory head unit and disconnect the wiring. (Fig. A)

3Cut and remove the mounting tabs from the bottom of the Rear Support Tray (Fig. A). Cut and remove the slots on the bottom of the ISO Brackets (Fig. B). Locate tabs "B" on the ISO Brackets for mounting, cut and remove tabs "A" (Fig. C). Cut and remove all mounting clips on the Radio Housing. (Fig. B)

Skip to step #3b on Page 10.

A

B	Fig. A
	Fig. B

"B"

Fig. C

7