OPERATING YOUR WATER DISPENSER
?Steps to replace water bottles
?Use a clean cloth to wipe off neck of bottle.
?Remove cap.
?Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on opening of bottle while placing in reservoir.
?Insert the water bottle on the water intake over reservoir opening so it settles properly on it.
?Wipe off any water which may have splashed on dispenser top.
?When a new bottle is installed you must open the hot water faucet and remove no less than 4 full cups of water to insure the water flows properly and the water reservoir is at the proper level.
?Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a
Plug the appliance into an exclusive properly
This appliance requires a standard
The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance.
?Cold Water Control
Turn the cooling switch on. The green indicator will be lit on and the process begins. When the water reaches the right temperature the green light goes off automatically.
?Hot Water Control
Turn the heating switch on, the red indicator will be lit on and the heating process starts. When the water reaches the right temperature the red light goes off automatically. When the temperature goes down to approx. 80º C (176º F), the red indicator will glow again and another heating process starts.
NOTE:
THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT.
To dispense hot water:
?Slide red safety button to the left and hold while pressing downward on hot water faucet to dispense hot water.
?Safety button will return to its original position when faucet is released.
10