Bloomfield 8372 owner manual Access Panels, Temperature Adjustment, Servicing Instructions

ACCESS PANELS

Top panel is held by four screws at the corners.

Front panel is held by two clips under each warmer plate, three screws at the bottom and a retaining lip at the top.

Top rear panel is held by two clips under the warmer plate.

Fig. 8 Access Panels

TEMPERATURE ADJUSTMENT

With the “READY TO BREW” light ON, draw a cup of water from the hot water faucet. Check the temperature of the water with a thermometer of known accuracy.

If temperature adjustment is necessary, remove water bottle and top panel.

Adjust thermostat by turning shaft; clockwise increases temperature. 1/8 turn = approximately 10ºF.

Refer to Table 1 below for proper brewing temperature based on altitude.

Upon completion, reinstall top panel.

SERVICING INSTRUCTIONS

CAUTION

Electric Shock

Hazard

Opening access panels or removing warmer plates on this brew may expose uninsulated electrical components. Disconnect brewer from electrical power before removing any panel or warmer plate.

NOTE:

Each warmer plate has a center stud which screws into a bracket. Warmer plates on Canadian brewers are secured with a nut. Remove button plug on bottom of brewer to access nut on warmer plate. Remove warmer plates by turning counter-clockwise.

NOTE:

Optimum brewing temperature range is 195ºF to 205ºF (90ºC to 96ºC).

IMPORTANT:

Amechanical thermostat will maintain temperature within ±5ºF. To prevent boiling water in the brewer, thermostat should be adjusted to a maximum temperature equal to the local boiling temperature minus 5ºF.

Table 1 Boiling Temperature by Altitude

11