Installation and Connection Instructions
•If the dishwasher is installed under- neath a kitchen work surface, the original work surface of the dish- washer is to be removed as follows:
–Unscrew the screws (1) from the elbows on the back side.
–Slide the work surface approx. 1cm to the rear (2) , lift at the front (3) and remove.
–Press the work surface retaining brackets at the position shown in the diagram (4) and remove the bracket at an angle to the rear
(5).
4 |
5 |
1 | If the dishwasher is later used as a | ||||||
| work surface must be | ||||||
3 The plinth on | |||||||
| • | ||||||
| fitted with a décor panel to match | ||||||
| the facings of other kitchen equip- | ||||||
| ment. The décor panels must be |
|
| ||||
|
| ||||||
| obtained from the kitchen manu- |
|
|
|
|
|
|
|
|
|
|
|
| ||
| facturer. A décor frame is necessary | ||||||
| for installation, and can be |
|
|
|
|
| |
| obtained as an accessory from the |
|
|
|
| ||
| dealer if not included in the scope |
|
|
|
|
|
|
| of delivery. |
|
|
|
| ||
|
|
|
|
|
|
|
|
• Decor panel dimensions:
– Height 590 mm
–Width 581 mm
–Clamp thickness: max. 4 mm
•To ensure that thin decor panels do not flex or distort, attach them to the door of the appliance using double sided adhesive tape.
34