AEG 5270 I Leak Prevention System, Electrical connection, Appliance is automatically pumped out

Page 37

Installation and Connection Instructions

 

Leak Prevention System

 

For protection from damage due to water leaks, the dishwasher is

 

equipped with a leak prevention system, the AQUA CONTROL SYSTEM.

 

In the event of a fault, the safety valve immediately interrupts the sup-

 

ply of water to the appliance and the drain pump switches on. By this

 

means water can neither escape nor overflow. The remaining water in

 

the appliance is automatically pumped out.

1

The AQUA CONTROL SYSTEM also works when the appliance is switched

 

off – the appliance must however not be disconnected from the mains.

Electrical connection

1

In compliance with electric company technical requirements for mains

 

connections, hard-wired connections to the mains may only be made

by approved electri-cians.

When connecting the appliance, observe the German VDE regulations and, if applicable, any additional conditions required by your local elec- tricity supplier. Following installation, live parts and live insulated wir- ing must not be accessible using a finger test in accordance with EN 60335/DIN VDE 0700.

Information on the electrical connection can be found on the rating plate on the right side of the inner edge of the dishwasher door. If the appliance has a change-over switch, the additional instructions on the change-over diagram in the mains connector box must be observed.

Prior to connecting ensure that the mains voltage and current rating at the site of installation match the nominal voltage and current rating given on the rating plate. The required fuse protection is also to be found on the rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

If the appliance is hard-wired to the mains supply, then it must be safely isolated from the mains within the electrical installation with switches intended to ensure all-pole(N,L1)disconnection, shall be directly connected to the supply terminals and shall have a contact separation (fuses, cut outs, current trips or similar) of at least 3mm in each pole.

37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Ökofavorit 5270 Dear customer Tips on using the appliancePlease read these user instructions carefully Use of the appliance are marked with a clover leafContents Installation and Connection Instructions Installation, Connection and Placing into Operation Safety InstructionsChild Safety Correct Use General SafetyDisposing of the Packaging Material DisposalDisposal of old appliances POM For polyoxymethylene, e.g. plastic clipsEconomical and Ecological Dishwashing Appliance Features and Control Panel Indicators have the following meanings Prior to using for the first timeControl panel Adjust Number Adjust the water softenerHardness range of the water in your area Fill with special salt Filling with Special Salt for the Water SoftenerUse special salt Place the funnel supplied on the con Tainer openingPage That you glasses are clear Filling with Rinse AidWould damage the appliance Fill with rinse aidDaily Use Adjusting Rinse Aid DosingNot be washed in the dishwasher Loading cutlery and dishesBefore loading the dishes, you should BaseLoading Cutlery Ticularly to children see Safety InstructionsPlace the grid insert on the cutlery rack BasketLoad large and heavily soiled dishes in the lower rack Loading Pans, Frying Pans and Large PlatesLoading Cups, Glasses Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketRaising the Upper Basket Pull the upper basket out completelyUse only dishwasher detergent Filling with DetergentFill with Detergent Tions given on the detergent packagingBio Wash Programmes and Concentrated Detergents Selecting the Wash Programme Programme Table Start the wash programme Changing/Interrupting/CancellingWash Programme Changing the wash programmeLoad Sensing Sensor Logic Switching Off the Dishwasher Care and CleaningEmptying the Dishwasher Cleaning the Filter What to do, when Error Messages Are DisplayedMalfunction Possible Cause Remedy Wash results are not satisfactory Problems occur during use of the dishwasherDishes are still dirty Wrong wash programme was selectedDishes are wet and dull Technical DataRinse aid was not used Rinse aid container is empty Lower rinse aid dosingUpper rack Bottom rack with cutlery basket Example Loading ArrangementAn open-end spanner Screwdriver Installing the DishwasherBuilt-In Dishwasher Dishwashers That Can Be IntegratedFree-Standing Appliances Work surface must be re-mounted Plinth on free-standing appliances is not adjustableFree-standing appliances can be Fitted with a décor panel to matchWater Connection Connecting the DishwasherPermitted water pressure Connect the inlet hoseDrain hose Water drainExtension hoses Extension hoses are available fromElectrical connection Leak Prevention SystemAppliance is automatically pumped out Connections Egypt Kanada Mauritius E. Abu Dhabi Jordan MaltaAustralia Korea South Namibia Croatia New ZealandHongkong Lthuania Estonia LataviaIsrael Malaysia Japan SingaporeAutres agences étrangères assurant le service après-vente Further after-sales service agencies overseasWeitere Kundendienststellen im Ausland Otros puntos de Postventa en el extranjeroPage Service

5270 I specifications

The AEG 5270 I is a highly regarded appliance that exemplifies the brand’s commitment to innovation and efficiency in the home appliance sector. This model stands out for its combination of modern design, advanced technology, and practicality, making it an excellent choice for various households.

One of the key features of the AEG 5270 I is its energy-efficient performance. The appliance is designed to consume minimal energy while delivering optimal results, aligning with contemporary environmental standards. Its energy rating not only reflects a commitment to sustainability but also greatly contributes to cost savings on utility bills over time.

Technologically, the AEG 5270 I incorporates smart sensor technology. This feature not only simplifies the user experience but also ensures precise operation by adjusting settings according to the load and type of items being processed. The sensors optimally regulate temperature and timing, delivering perfect results with every use.

Furthermore, this model is equipped with a user-friendly control panel. The intuitive interface allows users to navigate various settings easily, making it accessible for all family members. Additionally, the AEG 5270 I includes customizable programs, allowing users to select the most suitable modes for specific requirements.

Another vital characteristic of the AEG 5270 I is its spacious capacity. It comes with ample room to accommodate large loads, making it ideal for families or those who frequently host gatherings. The thoughtful design maximizes interior space without compromising efficiency, enabling users to complete chores faster.

The build quality of the AEG 5270 I is noteworthy as well, featuring robust materials that ensure durability and longevity. Coupled with this is the brand’s reputation for reliable performance, offering peace of mind that the appliance will function effectively for years to come.

In terms of safety, the AEG 5270 I incorporates several measures to protect users and the appliance itself. Features like child locks and robust insulation ensure that the appliance operates safely in any household environment.

All these attributes coalesce to make the AEG 5270 I a standout choice in today’s market. Its blend of efficiency, advanced technology, and user-centric design caters to the needs of modern households, setting a high standard for what consumers expect from home appliances.
Top Page Image Contents