16
USING THE DETERGENT
A | B |
|
|
|
|
| 30 | M AX | |||
| 20 | 4 | 3 | 2 | 1 |
|
|
| - | ||
| + |
|
| ||
|
| C |
|
| |
CAUTION!
Use only detergents for dish- washers.
1.Press the release button (B) to open the lid (C).
2.Put the detergent in the compart- ment (A) .
3.If the programme has a prewash phase, put a small quantity of de- tergent on the inner part of the ap- pliance door.
4.If you use detergent tablets, put the tablet in the compartment (A).
5. Close the lid. Make sure that the release button locks into position.
| Do not use more than the cor- |
| rect quantity of detergent. Refer |
| to the instructions on the deter- |
| gent packaging. |
| Detergent tablets do not fully |
| dissolve with short programmes |
| and detergent residues can stay |
| on the dishes. |
| We recommend that you use |
| detergent tablets with long pro- |
| grammes. |
|
|
SETTING AND STARTING A | 2. Press the on/off button to activate |
PROGRAMME | the appliance. Make sure that the |
| appliance is in setting mode. |
Setting mode
The appliance must be in setting mode to accept some operations.
The appliance is in setting mode when, after the activation:
•The display shows two horizontal sta- tus bars.
If the control panel shows other condi- tions, press RESET until the appliance is in setting mode.
3.Set the programme.
•The related programme number flashes in the display.
4.If you want, you can set the options.
5.Close the appliance door. The pro- gramme starts.
•The display goes off. If you open the door while the appliance op- erates, the display shows the pro- gramme duration that decreases with steps of 1 minute.
Starting a programme without | Starting a programme with | |
delay start | ||
delay start | ||
|
1. Open the water tap. | 1. Set the programme. |
|