AEG 88060 user manual Troubleshooting, Problem Possible cause Possible solution

ENGLISH 19

TROUBLESHOOTING

The appliance does not start or it stops during operation.

First try to find a solution to the prob- lem (refer to the table). If not, contact Service.

With some problems, the display shows an alarm code:

• - The appliance does not fill with water.

• - The appliance does not drain the water.

• - The anti-flood device is on.

WARNING!

Deactivate the appliance before you make the checks.

Problem	Possible cause	Possible solution
The programme	The mains plug is not con-	Connect the mains plug.
does not start.	nected in the mains socket.
	The appliance door is open.	Close the appliance door.
	The fuse in the fuse box is	Replace the fuse.
	damaged.

The delay start is set.

Cancel the delay start or wait for the end of the countdown.

The appliance does	The water tap is closed.	Open the water tap.
not fill with water.
	The water pressure is too	Contact your local water au-
	low.	thority.
	The water tap is clogged or	Clean the water tap.
	there is limescale on it.
	The filter in the water inlet	Clean the filter.
	hose is clogged.
	The water inlet hose has a	Make sure that the position
	kink or a bend.	of the hose is correct.
	The anti-flood device is on.	Close the water tap and
	There are water leakages in	contact Service.
	the appliance.
The appliance does	The sink spigot is clogged.	Clean the sink spigot.
not drain the water.

The water drain hose has a kink or a bend.

Make sure that the position of the hose is correct.

After the checks are completed, acti- vate the appliance. The programme continues from the point of interrup- tion.

If the problem occurs again, contact Service.

If the display shows other alarm codes, contact Service.